Reddit reviews 24V 5Amp Automatic Battery Charger Maintainer, Car Battery Charger Maintainer with Alligator Clips for Scooter, Wheelchair, Motorcycle, eBike, Lawn Mower Electric Tools Emergency Light etc
We found 1 Reddit comments about 24V 5Amp Automatic Battery Charger Maintainer, Car Battery Charger Maintainer with Alligator Clips for Scooter, Wheelchair, Motorcycle, eBike, Lawn Mower Electric Tools Emergency Light etc. Here are the top ones, ranked by their Reddit score.
【"TPE" SPECIFICATIONS 】: Input Voltage: 100-240Vac@50/60Hz; Maximum charging current: 5A; Charger Output Amperage: 5A; Charging Battery (Ah): 15-100Ah,We are the only genuine seller of this product. In order to maintain market order and your purchasing experience, please look for the trademark: TPE.【"TPE" UNIQUE DESIGN】: 24-volt AGM battery charger is the Blue aluminum body, with Red LED power indicator and 4 charging progress green LED lights. A built-in large fan can provide good heat dissipation to extend the life of the charger.【"TPE" FASTER CHARGING】: 24V battery charger input is AC100-240V for worldwide used with rechargeable AC cord C13 inlet, Output constant current can faster charging【"TPE" WIDELY USED】: 5A 24V Automatic battery charger with Alligator Clips. Great for charging your WHEELCHAIR, CAR, MOTORCYCLE, MARINE, AND RIDE-ON TOY Batteries, suit for the type of batteries included 12V/24V/36V/48V all SLA / VRLA / Flooded (Wet) / Calcium type deep cycle / GEL / AGM lead-acid batteries and deep-cycle【"TPE" SAFE PROTECTIONS & SERVICE GUARANTEE】: 24 Volt fully automatic 4 steps automatic battery charger by Microprocessor controlled with soil 4LEDs charging indicator. Short circuit; Over-voltage protection; Over-current protection; Overload Protection, motorcycle battery charger with UL / CE / CCC safety.
Remotely Monitoring DC Voltage
The cheapest way that I've found to monitor DC voltage from an ethernet-accessible interface, is with a routerboard. This RouterBoard is compatible with 10V-30V DC, uses just a few watts (less than 5 usually), and gives a current voltage read-out that you can read with a web scraper or SNMP. It's also dirt cheap.
​
Remotely Monitoring AC Up/Down Status
The easiest way to monitor AC status is to use any kind of device with an ethernet port that runs on non-backed-up AC power. You plug the unit into raw AC, and the ethernet port into a switch or router that can send an SNMP trap to your monitoring utility. When the port sends an ethernet down trap, your AC is off. This device would work fine, and it's also dirt cheap.
​
Solar + AC Charging
Don't go crazy trying to find a solar charge controller that has dual input. Instead, run an AC charger in parallel into your battery bus, and set the AC charger to a .1VDC set point lower than your solar charge controller. This will prioritize solar charging, but also ensure that AC floats the batteries at a reasonable charge current when solar is off. And - you guessed it - it's also dirt cheap.
​
The BEST thing is that you can get up and running with all of the above for less than $100. Good luck and let me know if you want to compare war stories! I've been down this remote solar+AC site setup before...