Reddit Reddit reviews Additive Manufacturing Technologies: 3D Printing, Rapid Prototyping, and Direct Digital Manufacturing

We found 1 Reddit comments about Additive Manufacturing Technologies: 3D Printing, Rapid Prototyping, and Direct Digital Manufacturing. Here are the top ones, ranked by their Reddit score.

Computers & Technology
Books
Computer Hardware & DIY
3D Printing Books
Additive Manufacturing Technologies: 3D Printing, Rapid Prototyping, and Direct Digital Manufacturing
Springer
Check price on Amazon

1 Reddit comment about Additive Manufacturing Technologies: 3D Printing, Rapid Prototyping, and Direct Digital Manufacturing:

u/ood_lambda · 2 pointsr/AskEngineers

Hm. I haven't actually read it, but if I was going to buy a book today it would be Additive Manufacturing Technologies: 3D Printing, Rapid Prototyping, and Direct Digital Manufacturing for several reasons:

  1. AM is a rapidly evolving field and it was published very recently (Nov 27, 2014).

  2. From reading the introduction and table of contents, it appears that it does a good job of discussing some very real issues with AM.

  3. There are several sections devoted specifically to medical applications

    I realize it's expensive, but in this case I think it's justified. Additive manufacturing/Rapid Prototyping is a great technology which will make an impact on manufacturing, but separating the hype from the reality is a nightmare from anything freely available. On the Hype Cycle curve, it is right around the Peak of Inflated Expectations. Even on reddit (e.g. /r/science, /r/askscience, /r/technology) you'd get the impression that AM/RP is a magic technology with absolutely no drawbacks or limitations and it will replace every other form of manufacturing in 5 years.

    Neil Gershenfeld has a quote I like:

    > The coverage of 3D printing is a bit like the coverage of microwave ovens in the 50s. Microwaves are useful for some things, but they didn't replace the rest of your kitchen

    I hope I don't sound too down on AM/RP because it has definitely made a substantial positive impact on our design and prototyping work. However, if I was interviewing a new engineer I'd be most impressed with one that can accurately describe when it's appropriate to use.

    Edit: These aren't bad if you just want a brief overview:

    An Insider’s View of the Myths and Truths of the 3-D Printing ‘Phenomenon’

    Why 3D Printing Is Overhyped (I Should Know, I Do It For a Living)

    I'm having trouble coming up with a decent article on tolerances which is perhaps the biggest limitation.