Reddit reviews BACOENG 3 Gallon Vacuum Chamber Kit with 3.6 CFM 1 Stage Vacuum Pump HVAC
We found 2 Reddit comments about BACOENG 3 Gallon Vacuum Chamber Kit with 3.6 CFM 1 Stage Vacuum Pump HVAC. Here are the top ones, ranked by their Reddit score.
3 Gallon Vacuum Chamber kit used to degass silicones, epoxies, essential oils, urethanes, etc.Silicone gasket to be used over 10,000 times without deterioration.Chamber Kit Include: 3gl SS Base; Acrylic Lid, Silicone Gasket; Vacuum Gauge; Air Manifold With Valves; 5ft HoseVacuum Pump Voltage:110V 60HZ Power: 1/4 HP Single Stage 3.6CFMPump Ultimate Vacuum : 0.8 Pa; Intake fitting: 1/4 inch Flare Oil Capacity : 220 ml
you probably need more material and a vacuum chamber.https://www.amazon.com/dp/B00W8ZU5FK/?coliid=IKPZI52V796YI&colid=3HUBTLT676WDO&psc=1&ref_=lv_ov_lig_dp_it
this is one i have on my list for my dice making project for later. You want to put your unpored resin into the chamber for 20 minutes, then put in your dice for 30 minutes. Always put something under your molds. you can leave the dice to cure for 20 some hours in the chamber turned off. If you want my dice amazon list i'll gladly hand it over.
https://www.youtube.com/channel/UCiocf36TFwHWWtyfajz6Aqg
This guy gives lots of good tips.
I use this vacuum chamber
BACOENG 3 Gallon Vacuum Chamber Kit with 3.6 CFM 1 Stage Vacuum Pump HVAC https://www.amazon.com/dp/B00W8ZU5FK/ref=cm_sw_r_cp_apip_OfvSxxeU3FZKP
And I use this pressure pot
California Air Tools 365B 5-Gallon Pressure Pot https://www.amazon.com/dp/B008FQEC6Y/ref=cm_sw_r_cp_apip_GIVbOaA1tAb1O
I also had to get some fittings and modifications for the pressure pot but I can't recall exactly what. I like quick disconnect hoses and fittings and the pressure pot didn't come with anything.
To be honest you don't really need a vacuum chamber, depending on the application. Smooth-on Smooth Cast 325, 326, or 327 are all low viscosity and don't seem to bubble as much. You can get by with just a pressure pot and an air compressor.
For the love of all that is holy, though: PLEASE WEAR GOGGLES. I can't stress it enough. Resin in your eye will ruin your vision. Also, when dealing with pressure you're always running the risk of a breach and even dust at 50PSI can ruin your vision.