Reddit reviews Behringer Monitor Speaker And Subwoofer Part (NX3000D)
We found 1 Reddit comments about Behringer Monitor Speaker And Subwoofer Part (NX3000D). Here are the top ones, ranked by their Reddit score.
Delivers 2 x 1500 watts into 2 ohms; 2 x 900 watts into 4 ohms; 3000 watts into 4 ohms (Bridge mode) and weighs less than 7.9 lbs/ 3.6 kgUltimate reliability through revolutionary cool-running high-density Class-D technology with "near-zero" Thermal buildupUltra-efficient switch-mode power supply for noise-free audio, superior transient response and low power consumptionHigh-performance DSP and 24-bit/96 kHz converters deliver ultimate signal integrity and extreme dynamic rangeDsp section features sophisticated delay, crossover (3 filter types, up to 48 dB/octave), EQ (8 parametric, 2 dynamic), dynamics processing and lockable security settings
Crown XLS 1502 should fit the bill.
NX3000D if you want DSP baked in.
The Crown should be a tank, but a ton of DIY people have used the Behringer without issue.
My opinion: If you're gonna build your boxes, over-build them and sell your Velodyne to compensate. You'll get better response with matching drivers in your room. When you combine your exisiting 10" with 12"s, 15"s, 18"s, or whatever the fuck they're doing with 24"s now you get different output at different Dbs along the frequency response which leads to it sounding weird in-room.
At one point I ran one 15" Ultimax along side my 10" SVS and results were pretty meh. Can you do it? Sure. It's your rig and you can run what sounds good to you but if you wanna do it "right" match the size of your subs across the board.