Reddit reviews Camco 59953 Propane Fitting - 1/4" Male NPT x 1/4" Female Inverted Flare
We found 3 Reddit comments about Camco 59953 Propane Fitting - 1/4" Male NPT x 1/4" Female Inverted Flare. Here are the top ones, ranked by their Reddit score.
For use with some regulatorsConnect a 1/4" inverted flare pigtail to a regulator with 1/4" female NPT port(s)Sold brass construction1/4" Male NPT x 1/4" Female Inverted FlareEasy to install
Check the tokecity link above for basic how to. You buy most of the parts from glaciertanks.com and the rest:
Can tapper: http://www.amazon.com/gp/product/B0009XT7NY/ref=oh_details_o05_s00_i00?ie=UTF8&psc=1
(remove the schrader valve on the side you use and also the ball in the inside as well.)
Ball valves: http://www.amazon.com/gp/product/B0014JC9HI/ref=oh_details_o07_s00_i00?ie=UTF8&psc=1
(I had to file down the end of the ballvalve where the adapter fits on because at first it was only held on by one thread. Making the ball valve shorter allowed it to fit inside the adapter deeper and make contact with more threads)
Adapter: http://www.amazon.com/gp/product/B0056ODEP8/ref=oh_details_o02_s00_i00?ie=UTF8&psc=1
(take a pair of needle nose pliers to remove the unnecessary internals that would reduce the flow rate.)
I got the T splitter from ebay. I found one with male 1/4" NPT on the bottom and female 1/4" NPT on each side.
I used a set up like this when I open blasted, the ball valves create a very good seal without tape, ratcheted down tightly with a wrench.
You'll need a inverted flare adapter to use these valves, to convert the male end to NPT threads.
I would always place a filter before the material, to filter out potential paint particles (heard claims that it scrapes paint into the butane) but I never found any paint, and I used both coffee filters and 25 micron mean screens.
I liked can tappers, as it provides a good deal more pressure for open blasting. I used less butane.
here is my parts list lol i think this would be a better idea splitter. can-tap. going from the splitter to my glacier top. and camico adapter. and ball valves. Does this look adequate or which part do I need to be able to press the valve depressor?