Reddit reviews Craftsman Bolt-out 5 Piece Damaged Bolt/Nut Remover Set
We found 6 Reddit comments about Craftsman Bolt-out 5 Piece Damaged Bolt/Nut Remover Set. Here are the top ones, ranked by their Reddit score.
Includes: #8 (14mm & 9/16-Inch), #9 (15mm), #10 (16mm & 5/8-Inch), #11 (17mm & 11/16-Inch) and #13 (19mm & 3/4-Inch)Equipped to take on a larger range of bolts in engines, furnaces and appliances,It features both ½ inch drive and hex external drives, get the right grip for optimum torque.Machined with precision from hardened steel, and built to last.Black oxide coating prevents corrosion while the blow molded Case keeps it organized
"Damaged nut extractor socket."
Amzn.com/B007C6KKAK is an example of a set.
The cheaper ones on Amazon usually work for a single use (maybe), and the inner points get flattened so they won't grip as well if you use them again. The better kits (the one I liked to is borderline) will last a long time and have a "lifetime guarranty."
I guess he doesn't know thats what bolt-outs are for! They carry them at most of the local auto shops, autozone, pepboys, advance auto. Had to use them a few times when I lost my lugnut key...
https://www.amazon.com/Craftsman-Bolt-out-Piece-Damaged-Remover/dp/B007C6KKAK/
http://www.amazon.com/gp/aw/d/B007C6KKAK Use this, or something similar. Either buy regular lug nuts to replace the lockers, or buy a new set of lockers to replace them, it will come with a key that fits.
Personally, I'd go with the regular lug nuts, cause the only people those lockers will stop are people who care about damaging the vehicle, which is limited to you pretty much. They're not even going to slow down a decent thief if they decide they want your wheels.
I had the same problem when I went to remove mine. I had one if these in much smaller sizes in my toolbox, one of them happened to be just the right size and finally got it out.
My next attempt was going to use one of these, I've had pretty good luck with them in the past. They have a drill bit on one end and extractor on the other - drill first, then flip it over and insert the extractor. The drill part is reverse-threaded so sometimes it bites hard enough to back it out without even using the extractor. GO SLOW and apply lots of feed pressure.
https://www.amazon.com/Craftsman-Bolt-out-Piece-Damaged-Remover/dp/B007C6KKAK/ref=pd_sim_263_4?ie=UTF8&dpID=41Wji8wmtlL&dpSrc=sims&preST=_AC_UL160_SR160%2C160_&psc=1&refRID=AZTEXFQXVRFNHCGS8WC9
thoughts?
You need something like this...https://www.amazon.com/Craftsman-Bolt-out-Piece-Damaged-Remover/dp/B007C6KKAK/ref=sr_1_1?ie=UTF8&qid=1499262556&sr=8-1&keywords=easy+out+socket
Just make sure they are big enough to go around the lug...