Reddit reviews DEWALT Countersink Drill Bit Set #6, #8, #10, 3-Piece (DW2535)
We found 9 Reddit comments about DEWALT Countersink Drill Bit Set #6, #8, #10, 3-Piece (DW2535). Here are the top ones, ranked by their Reddit score.
The product is 3PC Countersink SetEasy and simple use kitThe product is manufactured in ChinaDrill, countersink and counterbore in one stepFour cutter countersink and tapered drill bit provide superior speed and ideal finishReplacement tapered bits offered
Do you mean the deck screws? If so, just get a countersink bit (available at any hardware store), unscrew and discard your current screws, use the countersink bit in the wholes you have already made and screw in new screws.
If you mean the other screws (the pan head sheet metal screws), unscrew them and use the other type of screws.
TL;DR Unscrew screws, countersink, screw new screws.
Edit: Linked to correct product. I had the wrong type.
These are what I'm used to.
http://www.amazon.com/gp/aw/d/B0000225OU/ref=mp_s_a_1_1?qid=1407665594&sr=1-1
I don't think metric/imperial is much of an issue of you're working with wood. You can always look up a conversion chart to make sure.
Good countersink bits
Splitting the wood -- other than pilot holes being too small, you might also try to countersink the wood to suit the screw heads, too.
Something like this:
https://www.amazon.com/DEWALT-DW2535-Piece-Countersink-Assortment/dp/B0000225OU/
Like the other guys said, its a pilot bit+drill bit+countersink.
I have the modern, replaceable bit, version set from Dewalt for prepping decking for screws. I love them
You did a good job with fit and finish. One thing I like to do when using screws is to countersink... I think it really improves the project. Take a look at this link below. You can drill a pilot hole and countersink in one swoop:
https://www.amazon.com/gp/aw/d/B0000225OU/ref=mp_s_a_1_2?ie=UTF8&qid=1525891819&sr=1-2&pi=AC_SX236_SY340_QL65&dpPl=1&dpID=51QMLOynRSL&ref=plSrch
These ones?
What about the bits with the counter sink built into the top?
Use a counter sink and tapered head screws, like drywall screws to install the tub.
counter sink will make the screw heads flush with the surface on the tiling flange.
Counter sink example
http://www.amazon.com/DEWALT-DW2535-Piece-Countersink-Assortment/dp/B0000225OU/ref=sr_1_1?ie=UTF8&qid=1408325845&sr=8-1&keywords=drill+bit+with+countersink
Careful tightening the screws, if you use a drill to drive them in set the clutch so you don't over tighten and crack the flange, might be best to do the final tighten by hand.
You can shim gaps under the screws with cedar shims. ( flange does not touch the stud ) then cut the shims off.
http://www.hardwarestore.com/36-count-16-red-cedar-shims-656434.aspx?utm_source=pla&utm_medium=cpc&utm_term=brand=nelson%20wood%20shims%20and%20adwords_labels=hardware&utm_campaign=rkg&device=c&network=g&matchtype=&creative=20650488858&adpos=1o4