Reddit Reddit reviews Dispense All - 9 Pack - 10ml, 3ml, 1ml Industrial Syringes with 14Ga and 18Ga Blunt Dispensing Tips and Caps - Great for Refilling and Measuring E-Liquids, E-cigs, E-juice, Wood Glue, Glues, Adhesives

We found 13 Reddit comments about Dispense All - 9 Pack - 10ml, 3ml, 1ml Industrial Syringes with 14Ga and 18Ga Blunt Dispensing Tips and Caps - Great for Refilling and Measuring E-Liquids, E-cigs, E-juice, Wood Glue, Glues, Adhesives. Here are the top ones, ranked by their Reddit score.

Industrial & Scientific
Lab & Scientific Products
Lab Utensils
Lab Dispensing Needles & Accessories
Lab Supplies
Dispense All - 9 Pack - 10ml, 3ml, 1ml Industrial Syringes with 14Ga and 18Ga Blunt Dispensing Tips and Caps - Great for Refilling and Measuring E-Liquids, E-cigs, E-juice, Wood Glue, Glues, Adhesives
10ml, 3ml and 1ml Industrial Syringes14 & 18 Gauge Luer Lock 1 Inch Blunt Dispensing TipsThe best variety of syringes with needles (blunt)Great for Refilling and Measuring e-liquids, e-cigs, e-juiceHandy for ink refilling and fountain pen refilling!
Check price on Amazon

13 Reddit comments about Dispense All - 9 Pack - 10ml, 3ml, 1ml Industrial Syringes with 14Ga and 18Ga Blunt Dispensing Tips and Caps - Great for Refilling and Measuring E-Liquids, E-cigs, E-juice, Wood Glue, Glues, Adhesives:

u/HCx · 6 pointsr/educationalgifs

Yes. Quite easily. The relationship is the following

If i have 1lb of force and want to lift something that weighs 4lbs i'll need two pistons right?

piston A with 1lb of force will have a surface area (pi*r^2) of idk, .5sqin.

piston B with 4lbs of load that you want to move will need a surface area 4x higher than piston A. so 2 sqin in this case.

The problem is when you move piston A 2 inches piston B (with the 4lb load) will only move .5 inches.

This scales linearly so if you want to lift a car with 1lb of force you can. but you better be able to move the piston a long long way to get the job done.

EDIT: a kit like this with some tubing will give you everything you need to demonstrate this at home. I don't know the tube diameters but you can measure them and figure out the ratio pretty easily. https://www.amazon.com/Pack-Refilling-Liquids-cigs-juice/dp/B01CFJ51X4/ref=sr_1_5?keywords=syringe&qid=1562950408&s=gateway&sr=8-5

u/xxtidariusxx · 5 pointsr/Vaping

all it takes is a bit of simple math. you can buy everything you need aside from the liquid nicotine on amazon. i myself use 100%vg juice so i dont buy pg at all but a large bottle of vg will run you about 20 to 25 dollars, 1 gallon for me is 22 at the moment. you can also find packs of empty bottles for around 10 bucks, then youll need measuring syringes for mixing, flavor drops and the nicotine all of which are linked below.

i would just mix small batches first if you arent sure what a juice would taste like after your done then mix a full bottle, this way you can experiment with flavor mixes and see what you can create.

for a 100 ml bottle its really easy youll just need to figure out how much nic to put in, i vape at 6% nic so i measure out 94 ml of vg and the last remaining 6 ml i put in as the nicotine, after that the base is done, then just drop in the flavor drops, shake it like crazy, let it settle for a bit and boom juice done.

there are also some sites out there with premade mixture recipes that you can find and follow

https://www.amazon.com/gp/product/B007HSDNS4/ref=ox_sc_act_title_1?smid=A3O37MU47F4102&psc=1

https://www.amazon.com/gp/product/B007Y8UX80/ref=ox_sc_act_title_2?smid=A1ZOAQ4ZHE42HG&psc=1

https://www.amazon.com/gp/product/B01CFJ51X4/ref=ox_sc_act_title_3?smid=A35C2NGNUSD9X5&psc=1

https://www.amazon.com/gp/product/B00WUPUYCC/ref=ox_sc_act_title_4?smid=A2S5SG4CMI156J&psc=1

https://liquidnicotinewholesalers.com/250mg-nicotine-liquid.html

u/mortelatte · 3 pointsr/AsianBeauty

I get mine from amazon.
https://www.amazon.com/gp/product/B016Q5YVK2/ - Assorted sizes set (out of stock)
https://www.amazon.com/gp/product/B0187LGYCG/ - 5ml Airless Pumps (about the size of my thumb)
I would LOVE to find a glass airless pump bottle though!

A fill syringe is awesome for decanting. You don't have to touch the product, and don't expose as much to air! I got the kind for glycerin and they work pretty well. The thicker creams are a pain, but you can use a syringe if you have patience.
https://www.amazon.com/gp/product/B01CFJ51X4/

u/Medic-Oil · 3 pointsr/bostontrees

That oil is very viscous you won’t be pouring it anywhere. (And those carts suck IMO). To answer your question, you need some blunt tipped syringes. I found a variety pack on amazon for less than $10.

I emptied one on these apex and another similar one from theory wellness (again, bad cart) into used mostly empty ones from sage (really good cart). Works fantastic.

To reduce viscosity and make it easier to suck up with the syringe, use a hairdryer on warm to throughly heat the cart and oil.

Edit:: link
Check this out: 9 Pack - 10ml, 3ml, 1ml Syringes with 14Ga and 18Ga Blunt Tip Needl... https://www.amazon.com/dp/B01CFJ51X4/ref=cm_sw_r_sms_awdb_8drXzb76J26XX

u/Mcgizzle1883 · 2 pointsr/trees

2% is NOT high thc....it’s extremely low! I’d also recommend to use a heavy indica strain given what you’ve reported since you’re looking for more calming effects vs. high energy. Your specific condition could be the cause of how you’re not feeling any effects, so it’s probably best to significantly bump up your intake.

Buy distillate syringes ($65 at Surterra) and just make infused coconut oil. Distillate is up to 90% thc and will go a long way....Plus you can truly control your dosages by concentrating them as much as you’d like.

All you have to do is heat up unrefined coconut oil in a Pyrex container, put the distillate into the hot oil and start stirring for a few minutes. Once it emulsifies it’s ready to use. The distillate is very thick, so put the syringe into hot water for a minute So that it becomes less viscous and then remove the cap to dispense it.

Example - let’s say there’s 850mg of thc in one distillate syringe and you use 50ml of coconut oil.

850/50 = 17mg of thc per ml of oil. You aren’t just limited to using one distillate syringe - feel free to use more to make your infused oil more potent.

Buy a blunt tip luer lock syringe with ml measurements and then simply put it into your own empty capsules. You can buy the syringe and the capsules on amazon for very cheap. You can also use these blunt tip syringes to measure your coconut oil to ensure he dosages will be right. Links to the items you need below

https://www.amazon.com/Pack-Refilling-Liquids-cigs-juice/dp/B01CFJ51X4/ref=mp_s_a_1_1_sspa?keywords=blunt+tip+syringe&qid=1554677628&s=gateway&sr=8-1-spons&psc=1

https://www.amazon.com/NOW-Gel-Capsules-250-Empty/dp/B00E40DJ82/ref=mp_s_a_1_7?crid=3VTB07WR7494G&keywords=capsules+00&qid=1554677715&s=gateway&sprefix=capsules&sr=8-7

You can also dispense the distillate straight into your own cartridges and vape it, but be sure to use only a ceramic cartridge. Do not include any coconut oil into your vape...just distillate

u/TheShadyMilkman206 · 2 pointsr/bettafish
  1. The only water conditioner I use is Seachem Prime. It is the best of the best. On top of that, due to only needing 1ml/10gallons it ends up being BY FAR the cheapest even though it has the highest price tag up front. Prime dechlorinates, neutralizes any ammonia or nitrite that might be present, and removes any harmful minerals.

  2. See previous number. 1ml/10 gallons

  3. Nope. Never had any need for it. What kind of "Sludge" do you have at the bottom of your tank anyway? That sounds like a symptom of something else.

  4. Prime is the fucking beeeeest. Prime can be dosed up to 5 times the recommended amount without any consequence. That being said, use syringes to dose anything in your tank.

    Prime is not overpowered at all. It is the best conditioner on the market hands-down. It is idiot-proof and is patented because it is so freaking awesome. Read Seachem's FAQ for more awesome info.

    TL:DR - Get yourself some Prime, throw everything else away, and never look back :).
u/Artemisa_of_Persia · 2 pointsr/DIYBeauty

It's this syringe. I think the problem may be the needle-like tip so I'll check out the baby syringe.

u/kwshi · 2 pointsr/fountainpens

Noodler's Ahab. You can use any sort of eyedropper-like tool, but I prefer a blunt-tip syringe, such as this one.

u/FlatulENTz · 1 pointr/Waxpen

In that case, the syringe is pretty handy to have. I got this variety pack from Amazon < link > so I could try different sizes, and the 1ml (smallest one) ended up working the best for me to load the B-coil.

u/Rec0de · 1 pointr/DIY_eJuice

After reading thru this site, here is my shopping list:

  • 500ml, 100Mg/ml Supercritical Nicotine/USP PG (CXTC)
  • Peach Colorless Flavor Concentrate by LA (4oz) (Wizard Labs)
  • Vegetable Glycerin USP
  • Gloves, Flasks, Syringes, Bottles

    Going for a 70pg/30vg blend, just need to track down a good e-juice calculator from the sidebar.
u/bevon · 1 pointr/cbdinfo

Yes. Don't mix it with any other juice.

This is what I did with my vape oil.

I got this from Max vapor nail. Refillable cartridge:

https://maxvapornail.com/collections/featured-products/products/glass-cartridge-with-ceramic-core-and-preheater-coil

You can use one of these pens right here for $24 with a charger:

https://o2vape.com/product/oil-vaporizer-battery-white/

I bought syringe from Amazon to use to fill the cartridge:

https://www.amazon.com/Pack-Refilling-Measuring-E-Liquids-Adhesives/dp/B01CFJ51X4/ref=pd_sbs_328_3?_encoding=UTF8&psc=1&refRID=ZK0EQ5Z4GBTKGNMP9ZWF


Hope this helps you. Here is the review I did on vaping using a refillable cartridge.

https://www.cbdreviews.net/max-vapor-nail-glass-cartridge-with-ceramic-core-preheater-coil/

u/ProfessorGumby · 1 pointr/fountainpens