Reddit reviews eBoot PVC Rubber Pin Backs, Black (100)

We found 2 Reddit comments about eBoot PVC Rubber Pin Backs, Black (100). Here are the top ones, ranked by their Reddit score.

Size: 12 mm in diameter, 7 mm in heightMaterial: PVC rubberFits for all lapel pins, tie tacks, citation bars, service bars and jewelryReplacement for pin clutch backsGood for jewelry making and DIY fun; The rubber pin backs are only compatible with the pin 1-1.2 mm in thickness, it can't fasten if the pin is too slim

Check price on Amazon

2 Reddit comments about eBoot PVC Rubber Pin Backs, Black (100):

u/MoldyCat · 1 pointr/NintendoSwitch

I've sadly lost so many pins to junk backings.

I swap and use these and have had zero issues.

u/JasonGGorman · 1 pointr/Vive

I am wondering if a small rubber earring back stuck into the cylinder below the rubber disc instead of the rubber disc might be a permanent fix. If anyone can supply accurate measurements of the cylinder's inside, outside and depth measurements, maybe we can find a small rubber earring back that fits. Is there a large gap between the thumpad and the rubber disc when it is not depressed? If not, this just may stay in place if it goes into that cylinder below where the rubber disc would be, only without glue. The repair would be simple, remove the disc and replace with an earring back. I was looking at these:

https://www.amazon.com/eBoot-Pack-Rubber-Backs-Black/dp/B01GDJTNEA

or these:

https://www.amazon.com/Plastic-Rubber-Clutches-Earring-Bullet/dp/B0176W5FPY

or these:

https://www.amazon.com/Plastic-Rubber-Clutches-Earring-Bullet/dp/B0176W5FPY