Reddit reviews Flex Tape Rubberized Waterproof Tape, 4" x 5', Clear, (Model: SG_B07B6F5PJ7_US)
We found 4 Reddit comments about Flex Tape Rubberized Waterproof Tape, 4" x 5', Clear, (Model: SG_B07B6F5PJ7_US). Here are the top ones, ranked by their Reddit score.
FLEX TAPE is a super strong rubberized waterproof tape that can patch bond seal and repair virtually everything!FLEX TAPE is specially formulated with a thick flexible rubberized backing that conforms to any shape or object!FLEX TAPE can be applied hot or cold wet or dry even underwater!FLEX TAPE instantly seals out water air and moisture to create a super strong flexible watertight barrier!FLEX TAPE is UV resistant VOC-free and has a wide temperature range so it can be used in extreme weather conditions!
https://www.amazon.com/Flex-Tape-Rubberized-Waterproof-Clear/dp/B07B6F5PJ7
https://www.amazon.com/Flex-Tape-Rubberized-Waterproof-Clear/dp/B07B6F5PJ7/ref=sr_1_25?crid=22X1PICZBXB31&keywords=clear+tape+heavy+duty&qid=1554473098&s=gateway&sprefix=clear+tape%2Caps%2C149&sr=8-25
get some clear tape :)
this ?
If you want to try and repair, you'll need some of this and some of this.
While a helper brings the pieces together to close the gap, cover the crack with the Flex Tape. Now, while still maintaining force to keep the crack closed, cut a piece of strap that will go on the outside of the bend and will reach both PVC flanges. Screw one strip on about an inch above that line on the PVC, using a screw for every other hole. Add a second strip one inch below.
Your helper is STILL applying pressure to keep the crack closed.
Cut another strip of metal, and wrap it around the elbow just next to the flange. Let it overlap 3"-4", then screw it in place. Cut another for the other flange.
That should be enough to hold everything in place.
Obviously, it would be FAR easier to replace the broken section. To do that, determine the diameter of the pipe and get 12"-18" of it (see if the hardware store has a scrap piece you can have for free). You'll need to buy two (2) of these, as you're going to have to cut the current elbow off, and that might not leave enough existing pipe left for the replacement elbow.
So, you'll end up gluing a hub to a small section (say 4") of pipe, and the other end of the pipe goes into the elbow. You'll make two (2) of these, once of each end of the elbow. You can prefit the parts before gluing them to see where you'll need to make cuts on the existing pipe. Make your cuts. Glue up the replacement elbow, small pipe sections and hubs, allow 30 minutes to set up. Apply glue to the ends of the existing pipe and the interior of both hubs, push them into place. Done.