Reddit reviews Gardner Bender GHG-1525 6PK 1/4" Grommet
We found 3 Reddit comments about Gardner Bender GHG-1525 6PK 1/4" Grommet. Here are the top ones, ranked by their Reddit score.
Snap into holes in steel boxes and sheetingProtect cable insulation from damageFlexible vinylBlack1/4 Inch Diameter Hole Grommets, Inside diameter, 3/8 inch drill hole, 1/2 inch overall diameter.
You are going to want to do this with the rubber grommets im telling you now. Seems multiple people have had that problem, and it would b e best for you to do it right from the beginning. https://www.amazon.com/Gardner-Bender-GHG-1525-Grommets-Protection/dp/B000BO9DSA these are the approximate size you want, and super glue them to the bottom of the esc bolts. Unless you bought the 10s2p kit i dont think this applies. but for the 10s5p it does for sure.
This noise has been driving me nuts ever since I got this kit (90mm hubs). I finally found a solution. These 1/4" hole grommets inserted over the bolt ends of the ESC PCB stack (held in place with a drop of glue) act as very effective vibration dampeners and also help isolate the ESC from coming into contact with the edges of the enclosure compartment. The grommets also lift the ESC above the vent holes so that air contacts the entire bottom surface of the ESC. My board rides silently now (allowing me to focus on the annoyance of creaky rear truck).