Reddit Reddit reviews GSI Creos Gundam Marker Basic Set (6 Markers)

We found 13 Reddit comments about GSI Creos Gundam Marker Basic Set (6 Markers). Here are the top ones, ranked by their Reddit score.

Art Drawing Supplies
Artists Drawing Media
Drawing Pens
Arts, Crafts & Sewing
Painting, Drawing & Art Supplies
GSI Creos Gundam Marker Basic Set (6 Markers)
Colors include gray, white, yellow, blue and red and 1 fine tip gray marker5 Chisel type marker tips and 1 Fine tip marker for panel linesPaint can aso be extracted into a small tray to be handbrushed on
Check price on Amazon

13 Reddit comments about GSI Creos Gundam Marker Basic Set (6 Markers):

u/crazypipo · 2 pointsr/Gunpla

If I plan on painting the kit, I cut every pieces out so that I can paint them all at once. However, I organize pieces into sections - L/R legs, L/R arms and so on. When I paint, each section goes on their on tray to prevent confusion. I have been building long enough that, even if I mix the parts together, I should be able to find what I need.


I try not to mix PG parts though. That's like finding that one piece you need in a pile of Lego.

-----

>cheap clippers to cut from the runner and then to try and cut closer to the part.

That's the cause of your problem. You should be using a sharp nipper and cut further away to the piece, then shave it down with a very sharp hobby knife or, if the gate is thin enough, cut against the piece with your nipper.

------

It is possible to polish the part with sanding only, however, it will take a lot of time and quite a bit of sand papers. Here is how I often hide my sanding

  • Cover it with Real Touch Markers or Gundam Markersand wipe off excess with cotton swaps. This is not a 'pro' method, but it works like a charm and takes almost no time. I only do this to my unpainted kits.


  • Primer/Surfacer. After I sand the entire piece with some fine grid sanding papers, I wash them to get all the residues. After the piece dry, I prime it with my Mr. Surfacer 1200, let it cure, then paint.

u/penguin055 · 2 pointsr/Gunpla

Was the one you bought by any chance this set? If it's that set, or one that looks like it, then all of the bigger markers are mainly for detail painting. The smaller one is intended for panel lining, but I'd suggest at least getting a black lining marker too, since gray is too light for many colors.

u/hardkhor · 1 pointr/Gunpla

I bought the set of gundam markers in the link below. However, when I tried to apply the gray, the gray looked darker than the gray from the runner. I smeared it to give it a feather effect but it was still too dark to be the same color. Am I suppose to let it dry first and then it would be the same shade of gray?

Also, this shade of gray of course only works of the darker one. What color is the one from the legs? Can't be th white one.... can it?

Lastly, is there a marker for epyon's color scheme if I want to continue with this method for epyon?

http://www.amazon.com/gp/product/B0009AFN0S/ref=oh_aui_detailpage_o04_s01?ie=UTF8&psc=1

u/flybylee · 1 pointr/Gunpla

So this was my first gunpla! I got impatient waiting for my gundam markers to come in (which are taking forever!) so i decided to try my hand at lining and using the decals. I wanted to put one i cared a little less about before i put together my SD Freedom Gundam. I was thinking about doing Freedom with some orange instead of blue (maybe), but wasn't sure how to do a metallic-ish orange without an airbrush :P

u/TheBlackFlame161 · 1 pointr/Gunpla

This is what I got. They shake like paint pens do, so I figured they were the same.

Thank you.

What is the purpose of the yellow, red and blue pens if you are just going to use the grey, black and brown ones?

u/Kalzic · 1 pointr/Gunpla

Hey everyone!

I'm as new as it gets. So, I made a shopping list after doing some research on everything that I think I need to start. I'll place the links to all the items in the lines below. Everything is on Amazon because... well why not?

Gundam

Glue

Marker

Tweezers

Knife

Cutters

Mat

More Markers!

*Krylon Matte Finish

Am I missing anything?



u/goodguydan · 1 pointr/Gunpla

A general pack like this, is a good starting point. If at some point you need a color outside of that set, try searching for an apporpriate color through hobbywave, or robot4less.

http://www.amazon.com/GSI-Creos-Gundam-Marker-Markers/dp/B0009AFN0S/ref=cm_lmf_tit_6


You can also use one of these for panel lining:

http://www.amazon.com/Gundam-GM01-Black-Fine-Line/dp/B0027ORJ10/ref=pd_sim_t_4

u/googoogiger · 1 pointr/Gunpla

Might this be something like you were talking about?

https://www.amazon.com/GSI-Creos-Gundam-Marker-Markers/dp/B0009AFN0S

u/CaptainButtons · 1 pointr/Gunpla

So i just got back from Asia and got a haul of HG and one RG and MG. I'm just getting back into Gunpla after a 10~year hiatus, and want to take a step up in to beginner level painting/panel lining/etc instead of just straight builds.

Some 1/144s I got that I want to start working on:
HGBF X-1 FullCloth (the one Lucas used in BFT)
V2 AB
HG Wing0
HGBF Wing Honoo? (Its a red.... Wing gundam?)
HD X Divider

I dont know the first thing about painting, and have watched some tutorials here and on youtube.

  1. Will the Gundam Colour markers be enough for beginner level of painting and cover most generic colours? I do have painting brushes/trays from my wife's painting tools.

    Gundam Marker basic set

    Gundam Marker Metallic

  2. I also brought a... thickish? panel line marker instead of a fine tip one. I think its GM301/302 or something. Lets just say i made a mess trying to panel line a SD (Gundam Base limited Musha Godmaru if that matters? ver Clear colour). Is this not used for panel lining? I bought this with recommendation from the staff at Tokyo Gundam Base (using Google Translate...)

  3. I randomly bought a Gloss spray from a shop in Akihabara? I believe that is branded Mr.Hobby? Should it be used because i paint/panel line? I've seen some say before but some also after? or should a gloss coat be done with paint instead of spray?

  4. I browsed around the web and see a "add-on" for HG V2 with the Wings of light effect, but can't seem to find it anywhere? Is there a way I can purchase this? I live in Canada Toronto if that matters.

    Thanks in advance for the random questions.
u/3dbello · 1 pointr/HotWheels

Thanks! I use some paint pens! GSI Creos Gundam Marker Basic Set (6 Markers) https://www.amazon.com/dp/B0009AFN0S/ref=cm_sw_r_cp_api_i_9qmsDbBKTQP2B

Those are the ones I use. Take some getting used to. So practice on some junk castings first 😆😂

u/Manpig · 1 pointr/Gunpla

Here's the basic set that is associated to the classic Gundam colors. There are many more sets that you can buy if you are willing to search around for them.