Reddit Reddit reviews iSonic P4810 Commercial Ultrasonic Cleaner, 2.1Qt/2L, 110V for Brass, Gun Parts, Carburetor Cleaning

We found 7 Reddit comments about iSonic P4810 Commercial Ultrasonic Cleaner, 2.1Qt/2L, 110V for Brass, Gun Parts, Carburetor Cleaning. Here are the top ones, ranked by their Reddit score.

Industrial & Scientific
Lab & Scientific Products
Lab Instruments & Equipment
iSonic P4810 Commercial Ultrasonic Cleaner, 2.1Qt/2L, 110V for Brass, Gun Parts, Carburetor Cleaning
iSonic P4810 Commercial Ultrasonic Cleaner, 2. 1Qt/2L, white color, plastic basket, heater, 110VStainless Steel Tank, Tank Size 7. 2"x6"x3", Tank Capacity 2. 1Qt/2L.Ultrasonic Frequency 35, 000 Hz, 110V 135WTimer Settings: 1 to 30 minutes full range timerHeater preset at 140F/60C; Cooling fan; Overheat protector; Uniform ultrasonic energy through out the tank, making it the best for uniform cleaning and for mixing applicationsPlastic basket includedSuitable for brass cleaning for reloading, gun parts cleaning, carburetor cleaning and similar applicationsAlso suitable for liposomal vitamin c and other supplment making, steeping at home. See separate lisitng P4810+BHK01B, P4810+BHK03AAlso suitable for manicure, pedicure tools, dental labs
Check price on Amazon

7 Reddit comments about iSonic P4810 Commercial Ultrasonic Cleaner, 2.1Qt/2L, 110V for Brass, Gun Parts, Carburetor Cleaning:

u/nikondork · 4 pointsr/electronic_cigarette

This one. http://www.amazon.com/iSonic-P4810-Commercial-Ultrasonic-Cleaner/dp/B005GA1I3M/

I use it for both cleaning attys and speed steeping mixes. This unit is a little bit more expensive than some of the other entry models but the price is worth it. For starters, you can set it up to 30 minute cycles. It has an optional degas cycle and its also heated. I haven't seen any other units cheaper or the same price with heat.

When I'm cleaning attys and parts, I use the heat, only water with a single drop or two of dish detergent, 15-20min cycle with a degas cycle before. Gets threads really clean! After the cycle, I remove the basket and give everything a quick rinse with hot water from the tap, just to make sure any traces of soap are rinsed.

When I use it for juice, I use the heat with larger volumes of liquid or just hot water with fewer bottles. Full 30 minute cycle, vigorous shake (by now the VG is very warm and fluid), a 30 minute rest in the hot water, then another 30 minute cycle. I recommend you do this with caps ON. You can do this with caps off, but you need to come up with a way to keep the bottles upright since you need to fill the ultrasonic at a minimal level for it to work properly, they'll end up dancing around and tipping over. You can always let them breathe for a short period after the last cycle. I usually notice about a weeks worth of steep time with most flavors after this method.

u/Fromthe802 · 2 pointsr/NFA

This is what I use on my obsidian 45. isonic P4810. It has a 30 minute timer that I run twice in a row with a 1:1 simple green/distilled water solution.

Just a heads up, the plastic basket that comes with it broke after 2 uses and the company considers it an "accessory" that isn't covered by warranty.

u/qazme · 2 pointsr/DIY_eJuice

This is the one I bought ($90): iSonic P4810

Very large basket, heater (150 degree tested!), degause, up to 30 minutes on the timer - can run it for an hour without it needing a break. Quiet as well. Been a really nice performer over the last couple of months - very strong too.

Fit's 30ml in it just fine - could probably manage 8-10 bottles with ease(could fit a lot more if you lay them down - the lid hit them in the middle, I normally do 6 at a time.

u/CryptoVaper · 1 pointr/electronic_cigarette

I use this for washing and this for drying.

u/GeorgeSC · 0 pointsr/electronic_cigarette

here you go link

u/isonicinc · 0 pointsr/AskElectronics

I would recommend either our iSonic P4810 model (which has a tank size of 18.3x15.3x7.7 cm) or our P4800 (which has a tank size of 16.5x13.5x6.5 cm).

Either of these models can be purchased off of our website at http://www.isonicinc.com/ or Amazon at https://www.amazon.com/iSonic-P4810-Commercial-Ultrasonic-Extraction/dp/B005GA1I3M/ref=cm_cr_arp_d_product_top?ie=UTF8

OR

https://www.amazon.com/gp/product/B003Y72I92/ref=s9_dcacsd_dcoop_bw_c_x_5_w

I would also recommend that you try our iSonic Jewelry & Eyewear Cleaning Solution. This solution is capable of breaking down oil, dust, dirt, and other residue. Also available on our website or Amazon: https://www.amazon.com/iSonic-Ultrasonic-Cleaning-Solution-Concentrate/dp/B01DNP4U0O