Reddit reviews Mini Drill Chuck 1/4" Hex Shank for Micro Drill Bits

I have tried quite a few things for keeping multicore builds straight, allow me to save everybody the pain and bit of money of experimenting with this essay.

---

Aw man, those things sucked for me, assuming we bought the same ones... too weak, made of plastic and too large to be tight enough. Amazon disappointed me with this one. Glad they're working for you though!

Paperclips bend your wire and can screw everything over, especially if they're not tight enough. I tried special "Owl" paperclips and they still bent the wires like regular paperclips did.

Hair snap clips SERIOUSLY bend up your wire and don't even want to clip shut most of the time. Avoid, at least these particular ones.

Clothespins are too weak as well, at least the wooden ones.

I tried... I am not sure what they're called, they're the squeeze things that are on the strings of a hoodie, and the ones I bought were too weak, but would've worked nicely if the spring was better. These aren't the exact ones I bought, but they're the same thing.

I purchased two different Micro chucks (number 2) for my drill, they fit into the drill and have four jaws, but they're impossible to tighten enough for them to be worth using, your wires just fall out. Disappointing.

I purchased a Jeweler's Hand Vise and it works great, except that it comes out of the drill at a slight upward angle, with longer wires it causes everything to jerk around a bit which can snap 38g+ if you're not careful, especially at faster speeds, but besides that it's a great tool that I use all the time. Everybody should have one of these!

I bought a set of those fancy Patino's alien makers and mine are the older ones that need to be broken in first and believe me I've tried jamming many, many different things into those 3DPrinted pieces of crap to no avail, but the newer version apparently don't need to be broken in so I'm not absolutely writing them off.

Aaanyways, I found, on the floor while buying groceries, this tiny keyring. I have no idea where to purchase one, but it's about the size of a USD Penny and it's made out of what looks to be 14/16 AWGauge wire that had been wrapped around a sharpie three times. It's tight as hell and works the best out of anything I've ever used, I just wish I could find where to actually buy it.

Besides that, the old ribbon slider trick works well enough most of the time, just gotta carefully crimp them down with flat-nosed pliers.

I saw this thing and I'm incredibly tempted to purchase or make my own, as I believe it would be one of the most useful tools.

Last but most promising is this contraption and this one seems to be the improved 2.0 version. I would purchase one if I still had problems because I'm certain it would work amazingly, but the jeweler's hand vise works well enough, even with the jerkiness.

TL;DR, my personal suggestion is:

The absolute best thing I have discovered to keep multiple cores straight is a technique rather than a tool: put your wires into the drill chuck as straight as you can, bending them into Ls to match the three jaws and wrap 36-40g wire around the starting point of the wire like twenty times for about half of a centimeter and then crimp it down hard as you can with pliers while not bending the cores. It works so well that you don't even need to use anything else if you do it just right!

Hope all this can help you guys, feel free to share this information wherever with whoever whenever needed.