Reddit Reddit reviews Nilight 60001F-B Bar 2PCS 18w 4" Flood Fog Road Boat Driving Led Work Light SUV Jeep Lamp,2 Years Warranty

We found 12 Reddit comments about Nilight 60001F-B Bar 2PCS 18w 4" Flood Fog Road Boat Driving Led Work Light SUV Jeep Lamp,2 Years Warranty. Here are the top ones, ranked by their Reddit score.

Automotive
Automotive Light Bars
Automotive Lights & Lighting Accessories
Automotive Accent & Off Road Lighting
Nilight 60001F-B Bar 2PCS 18w 4
Super bright and wide illumination range: Advanced LED chips give out bright and white ray for clear visibility. Special designed lamp cup leads to wider illumination range, allowing you to see the left and right clearly.Better heat dissipation: Quick cooling aluminum alloy heat sinks and high-quality heat conduction silicone gel can effectively extend the lifespan of the light bar to over 30, 000 hours.High protective performance: IP67 Waterproof Rate, waterproof up to 1 meter of water for 30 minutes and effectively dustproof. The stainless mounting brackets are rustproof and anticorrosive.Adjustable mounting bracket: With adjustable mounting bracket, the work light can adjust to about 45 degrees, which makes changing direction easier. Widespread uses: The light bar can be compatible with almost all Jeeps, 4x4, Trucks, Motorcycles, SUVs, ATVs, Cars, Boats, etc. Many indoor and outdoor uses: Garden Lighting, Backyard Lighting, Back-up Light, Off Road Lighting, Construction Lighting and so on.Package include: 2PCS 18W Flood Led Pods
Check price on Amazon

12 Reddit comments about Nilight 60001F-B Bar 2PCS 18w 4" Flood Fog Road Boat Driving Led Work Light SUV Jeep Lamp,2 Years Warranty:

u/MikeINOPKS · 9 pointsr/GoRVing

Here are the rock light I used under the center. They seem pretty solid upon install and the initial use. I did run them through a hard rainstorm while plugged in and had no issues. I used two per side.

SuiTech SUI White Black LED https://www.amazon.com/dp/B013QLMFA2

Here are the reverse lights. I have these on my boat and they have survived two years of dunking without any trouble. They make life SO much easier for pulling the boat.

Nilight Led Light Bar 2PCS 18w https://www.amazon.com/dp/B00IY3YLCI

u/imjustincognito · 6 pointsr/XVcrosstrek

Spent the afternoon plastidipping my grill and adding a bar and lights. Shocked I managed to not fuck anything up.

Bar:
https://www.amazon.com/gp/product/B01EMYUOGY/ref=oh_aui_detailpage_o00_s01?ie=UTF8&psc=1


Lights:
https://www.amazon.com/gp/product/B00IY3YLCI/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1


Harness:
https://www.amazon.com/gp/product/B0155W7EDS/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1


Here are a few videos that did a great job walking me through the grill removal and the harness wiring:

Grill:
https://www.youtube.com/watch?v=qDe2xGbcpLc


Wiring:
https://www.youtube.com/watch?v=bPyvD4YJgZU
https://www.youtube.com/watch?v=zO_pYpy1eAk&t=635s


The only step that I took that the video didnt was taking a dremel to my dash plate to make the switch fit. Not as scary as it sounds!

u/ErectricCars · 3 pointsr/ebikes

this is the headlight I Attached it using duct bracketing and the rear light with this switch all running through this DC converter

Once you have a DC converter picked, you can basically just get 12v whatever you want from ATV, car, motorcycle etc. This is just the stuff I used.

u/K1K3ST31N · 1 pointr/Dualsport
u/igroplants · 1 pointr/ebikes

There is defiantly more than enough power to use automotive lighting. Let me phrase it like this. If you think about the typical power consumption of a tail light (mine is 40W at 12V), even with the addition of my headlights which are 18W a piece (supposedly) you’re only up to a total of 76W for the entire system. If we assume an inefficient driver we can round that up to 80W of additional power from your battery or a little over 1.5 A at 48V. Compare that to a 1000W motor running at half power (500W/48V= 10.4 A) so you’re adding a super small amount of constant draw (like 1/10 the normal drain) to have all you’re lights on all the time. Here are the parts I used:

Taillight: Greenclick 40W Motorcycle Tail... https://www.amazon.com/dp/B072Q5MK75?ref=ppx_pop_mob_ap_share

Headlights: Nilight Led Light Bar 2PCS 18W 4"... https://www.amazon.com/dp/B00IY3YLCI?ref=ppx_pop_mob_ap_share

Converter: Kohree DC/DC Converter Regulator... https://www.amazon.com/dp/B0756T983Q?ref=ppx_pop_mob_ap_share

Blinker relay: AUDEW 2-Pin Electronic Turn... https://www.amazon.com/dp/B011BTMDQM?ref=ppx_pop_mob_ap_share

u/Boonice · 1 pointr/klr650

they’re LED flood lights. Really good for night time trail riding. They mount right to the gen 1 front plastics/windshield factory screws without modification. I wired them to an aux switch and they only draw 36 Watts. One of my previous posts features a front view. Link below for the lights.
https://www.amazon.com/dp/B00IY3YLCI/ref=cm_sw_r_cp_api_cjP0Ab047CHPN

u/TH3_Captn · 1 pointr/AmazonTopRated

For some smaller led lights I'd suggest either these, which are a bit bigger than you expect but good quality or these which come highly recommended with almost 3k reviews and are at an excellent price point. On the 12" bar I don't have much experience but I've heard good things about "eyourlife" on amazon which is just a rebranding of the Chinese light bars but they're cheaper

u/Aedelmann · 1 pointr/motocamping

here is a generic pair I found on amazon searching, "12v LED light". They look to have solid reviews and be pretty identical to what I have. You're going to have to figure out your own custom mounting points.

u/Maverick524 · 1 pointr/Wrangler

Get some Nilights off Amazon. Think I paid like $20 USD for my cube floods. Build quality seems really nice too for the price.

Edit: https://www.amazon.com/dp/B00IY3YLCI/ref=twister_B07C6F31MH?_encoding=UTF8&th=1

u/jpsulisz · 1 pointr/Saturn_Cars