Reddit reviews PSI CSC2000C Barracuda Wood Lathe Chuck System
We found 4 Reddit comments about PSI CSC2000C Barracuda Wood Lathe Chuck System. Here are the top ones, ranked by their Reddit score.
Includes four(4) self-centering Jaw sets to hold Round and Square Stock for turning, pre-threaded for 1" x 8 tpi, and has an adapter for 3/4" x 16 tpi SpindlesIncludes #1 Step Jaws- for dowels: 1/32" to 1-1/2", holes: 11/16"to 3-1/8"Includes #2 Round Jaws, for dowels:1-1/2" to 2-7/8", holes: 2" to 3-1/2"Includes #3 Round Jaws, external grip 3-1/16" - 4-1/2"Includes Pin jaws which hold inside holes 1" - 2-1/2", and a screw chuck
yeah, I picked expensive hobbies (board games, photography, woodworking). Is there any reason not to get this PSI chuck set? Its about the same price.
Yup. This one..
Left about a 3-4mm tenon on the bottom - started with the screw chuck from the kit in a 9mm hole. I was worried that the jaws wouldn't hold on that well, but I ended up having to use the chuck to hold the bowl while I removed the screw drive with a crescent wrench. I'm very pleased with it so far.
I don't have a drill press. I have had great success with the Barracuda Wood Lathe Chuck and Drill Chuck. This works very well. Still need to tap it out slowly to prevent build up inside the tube.
Sorry, meant to link this one. I use this one as it's a little lighter and the 8x12 handles it pretty well: PSI CSC2000C Barracuda Wood Lathe Chuck System https://www.amazon.com/dp/B000KICC62/ref=cm_sw_r_cp_apa_SoUzybGE16974