Reddit reviews Rockwell RW9275 3/8-inch keyless drill chuck for ¼” Hex Drives
We found 2 Reddit comments about Rockwell RW9275 3/8-inch keyless drill chuck for ¼” Hex Drives. Here are the top ones, ranked by their Reddit score.
This light-duty keyless chuck attaches to ¼” hex drivesTraditional 3-jaw design with 3/8 maximum shank capacityNot suitable for impact drivers or applications involving high torque loadAllows screwdrivers with ¼” Hex quick-change chucks to use round-shank drill bits
It is a torque setting, but as torque gears up, max speed goes down. I should have said that more clearly.
There are a few ways to go keyless. You can replace the chuck, or you can use something like this in various configurations: http://www.amazon.com/Rockwell-RW9275-Keyless-Chuck-Accessory/dp/B005BTM5JY
No, you don't need titanium, but they're relatively cheap. Since 1/4 shank drill bits usually aren't being used in wood, they're made of a little tougher stuff for masonry etc. But these will be fine.
http://www.amazon.com/Tooluxe%C2%AE-10171L-4-inch-Titanium-13-Piece/dp/B000P6G74M/ref=pd_bxgy_469_img_2?ie=UTF8&refRID=1ZYCR1J8C8C1ZMH419NS
You can also get a drill chuck for your impact driver:
http://www.amazon.com/dp/B005BTM5JY?psc=1
And then just use any cheap drill bit.
http://www.amazon.com/Decker-15-110-General-Purpose-10-Piece/dp/B00280MC9M/ref=sr_1_5?s=hi&ie=UTF8&qid=1457123622&sr=1-5&keywords=drill+bit
The pot rack doesn't tell you the size of the hooks so you can't just buy one drill bit but drill bits are cheap. You want to choose a drill bit that is approximately the size of the shank on the ceiling hook, but you need to have it in hand to figure out. Hold the drill bit behind the threads on the hook and choose one where you can just barely see the drill bit between the threads.