Reddit Reddit reviews Sago Brothers Bonsai Pruning Scissors Pruner Shears for Bud and Leaves Trimmer 5 PCS

We found 18 Reddit comments about Sago Brothers Bonsai Pruning Scissors Pruner Shears for Bud and Leaves Trimmer 5 PCS. Here are the top ones, ranked by their Reddit score.

Gardening & Lawn Care
Gardening Hand Tools
Patio, Lawn & Garden
Gardening Scissors
Gardening Shears & Scissors
Sago Brothers Bonsai Pruning Scissors Pruner Shears for Bud and Leaves Trimmer 5 PCS
These pruning shears are designed for clipping small stems and light branches, trimming buds and leaves.Small and lightweight bonsai tools, also great for crafts, and other chores requiring small scissors.Sharpe blades make cutting more effortless, pop back open by themselves, very easy on hands!Maximum cutting capacity: 5/8" diameter. Clean with alcohol after use and lightly oiled if necessary.Package include: 5 x pruning shears. Size: 4 inch.
Check price on Amazon

18 Reddit comments about Sago Brothers Bonsai Pruning Scissors Pruner Shears for Bud and Leaves Trimmer 5 PCS:

u/dogcub · 44 pointsr/microgrowery

My hands would hurt so bad after a day of using those. I prefer bonsai trimmers like these. They’re cheap, you can trim just as tight, and they’re way easier on the hands.

u/Donkeydonkeydonk · 23 pointsr/microgrowery

Or..use spring loaded nippers.

u/glauck006 · 17 pointsr/microgrowery

Can I start off by saying that this well researched, well organized, informative post is a breath of fresh air compared to the "These balls mean its female, right?" and "Got clone, wat do guyz, lol" type posts, thank you for that.

I'd advise you skip the cheapo fan controllers and go with a Mercury 4 to maintain way tighter temp control. These controllers will raise and lower your fan speed to maintain a 10 degree swing. Or go full bore with the Arduino and control it with that.

A variac fan controller is also a good alternative to the cheap ones.

I'd also recommend a 6 inch setup as they're much more prevalent in home improvement stores. A six inch fan moving the same amount of air will also be quieter.

Consider Jack's hydro 321 if you're concerned you're paying a bit too much for Scott's brand bottled water... I mean GH nutes, sorry, I get confused sometimes.


I like these scissors.

https://smile.amazon.com/Sago-Brothers-Pruning-Scissors-Trimmer/dp/B00P0FK7W6/ref=pd_sim_86_23?_encoding=UTF8&psc=1&refRID=M6MNMDEB9656STMBFWVM

A 40x loupe will be hard to get pics with. People seem to have good luck with those phone attachment macro lenses.

You may need a temp controller for the seedling mat, but I've read of people using pencils under their seedling tray for a little air gap.

u/LazyGrower · 13 pointsr/microgrowery

Game changing: https://www.amazon.com/Sago-Brothers-Pruning-Scissors-Trimmer/dp/B00P0FK7W6

Just bought another 24 pairs of these babies.

u/DonutTread · 6 pointsr/microgrowery

I usually only grow 2 or 3 plants at a time so I'm probably not as particular about what I use to trim as others who end up spending days doing it. I am happy to use bonsai trimmers such as this

https://www.amazon.com/Sago-Brothers-Bonsai-Pruning-Scissors/dp/B00P0FK7W6/ref=sr_1_14?ie=UTF8&qid=1542645012&sr=8-14&keywords=trimming+shears

u/thomas533 · 5 pointsr/foraging

No pictures being as I am at work but:

u/DrOpThEmBuNzHuN · 4 pointsr/microgrowery

I use this style scissors for my fine trimming. I bought two pairs for a buck on wish.

Sago Brothers Bonsai Scissors, Pruning Shears for Bud and Leaves Trimmer 5 PCS https://www.amazon.com/dp/B00P0FK7W6/ref=cm_sw_r_cp_apa_DeANBbJVTGJQ5

u/imagrowsomestuff · 3 pointsr/microgrowery

https://www.amazon.com/gp/aw/d/B00P0FK7W6/ref=mp_s_a_1_5?ie=UTF8&qid=1527029595&sr=8-5&pi=AC_SX236_SY340_FMwebp_QL65&keywords=bonsai+shears

These are by far my favorite for trimming sugar leaves. Super precise and razor sharp, makes it really easy to cut leaves precisely. Use any type of larger shears or scissors for stems and branches.

u/AOSParanoid · 3 pointsr/microgrowery

https://www.amazon.com/gp/aw/d/B00P0FK7W6

I like these along with micro tip shears similar to the fiskars for larger leaves. These get a bit more precise for those little sugar leaves.

u/Stickybomber · 3 pointsr/microgrowery

These are the best for trimming. They look shitty but once you get them you'll be amazed at the quality. Razor sharp and a single one lasted me through trimming 5 plants before I felt they could be sharper.

http://www.amazon.com/Bonsai-Pruner-Bud-Leaf-Trimmer/dp/B00P0FK7W6

u/HuckleberryPoundTown · 3 pointsr/microgrowery

It sounds like you're being exceptionally picky when you trim? Maybe relax a bit? Are you trying to get every single little bit of leaf out?

My wife and I use a bunch of these little bonsai scissors. We keep a glass of alcohol out to soak the gunked-up ones in and just switch them out as needed. It takes us roughly an hour to trim a plant.

Our basic process is:

  • Cut all the branches and the cola off the plant.
  • Put em in a big box in the center of the table.
  • Lay out our scissors and other gear.
  • Get the cat off the table.
  • Stick a trash can by the table for the big stuff.
  • We each grab a branch.
  • Cut all the big fan leaves off and toss them. This takes maybe a minute per branch, probably less.
  • Cut off all the little popcorn buds. We throw these in a bowl and save them for extracts. Maybe another minute per branch.
  • Get the cat off the table.
  • Now we start cleaning up the individual buds.
  • Nip off any leaves that aren't sugary enough. Toss them. Maybe 5 minutes a branch.
  • Start cleaning up the buds. We just nip off anything that sticks out too far. We're mainly just shaping things up. Don't worry about digging into the buds to get every little trace of a leaf. If you can reach it easily enough, great, but no need to stress. This is the bulk of our time, maybe 10 minutes per branch.

    Edit: Oh, and if you're totally fine just extracting the plant, you really don't need to do much at all. I'd cut the fan leaves off since its quick and they're just needless bulk, but even that isn't mandatory.
u/Secret_Garden0_o · 2 pointsr/microgrowery

I used to use fiskars religiously. I still do occasionally but I mostly use these now...

https://www.amazon.com/gp/aw/d/B00P0FK7W6/ref=mp_s_a_1_6?ie=UTF8&qid=1526068853&sr=8-6&pi=AC_SX236_SY340_FMwebp_QL65&keywords=trim+scissors&dpPl=1&dpID=51x9w7rkW%2BL&ref=plSrch


I was looking to get another pair of fiskars and came across these. There work better than fiskars IMO bc they fit in your hand better. Plus they are cheap and clean easily

u/thesenseitofu · 2 pointsr/HotPeppers

These are the ones I got and I've been pretty happy with them so far. I'd love to get some nice forged ones someday though.

u/The_Real_Raw_Gary · 2 pointsr/trees

these are the ones I got

They’re amazing dude. The spring comes from the metal at the end. It’s basically two razor blades springing together. I don’t think I could go back to any type of actual scissor type shears after using these now. Also they’re cheap so if you didn’t want to clean them and just chuck a pair that’s a viable option as well. But they don’t make my hands hurt compared to the others so that’s the biggest thing for me next to how well they cut.

u/SilentMasterpiece · 1 pointr/microgrowery

Immediately after a full trim (im lazy so I only want to handle and trim my crop one time). Then its on to dry and cure. I have a big 4'x4' oak box I dry in. Its outside on covered patio, I keep a rh meter in it. I have some control over humidity in the box through leaving the lid fully open, slightly open, closed, water bucket... I drop buds in bags and leave open for the 1st day or so (im bud washing so humidity is a little higher than if not washing). I have rh meter in the bag, when it gets down to 60-70 or so I fold over and clip the top closed. I monitor the bags 2,3,4 times a day. Its true, a very important part of the grow is dry/cure. I bet 99% of the crops that get jacked end up worse or trash because the thief does not know how to dry/cure. Good Luck bro/

I use these for bud trimming

https://www.amazon.com/gp/product/B00P0FK7W6/ref=oh_aui_detailpage_o03_s01?ie=UTF8&psc=1

u/Con_O_Sewer · 1 pointr/microgrowery

https://www.gemplers.com/product/ARS320/ARS-Grape-Scissors

https://www.ebay.com/itm/Chikamasa-B-500sf-Stainless-Steel-Scissors-w-Fluorine-Coating-Resin-resistant/263795173535?epid=8016915205&hash=item3d6b6ae89f:g:IAQAAOSw7XNbPLH5

https://www.amazon.com/dp/B00P0FK7W6/ref=cm_sw_r_cp_apa_DeANBbJVTGJQ5

Heres what i grabbed except i got the curved and angled blade versions of the first two. Theres lots of other good ones though too im sure. I havent even tried these ones yet though so i cant really recommend them lol its just what i ordered after researching it.