Reddit reviews Xprite 7" Inch LED Halo Headlights for Jeep Wrangler JK TJ LJ 1997-2018(DOT Approved),CREE LED Chip, 90W 9600 Lumens Hi/Lo Beam with Halo Ring Angel Eyes DRL
We found 4 Reddit comments about Xprite 7" Inch LED Halo Headlights for Jeep Wrangler JK TJ LJ 1997-2018(DOT Approved),CREE LED Chip, 90W 9600 Lumens Hi/Lo Beam with Halo Ring Angel Eyes DRL. Here are the top ones, ranked by their Reddit score.
【HIGH-PERFORMANCE CREE LED CHIP】﹣DOT Approved. Newest Fantastic Design 7" LED Headlights w/ Angel Eyes Halo are more Brighter than Original Halogen and HID. 9600 LM / Kit; Over 50000 Hours Lifespan.【FOUR LIGHTING MODEs】- High Beam , Low Beam , Daytime Running Light and Amber Turn Signal Light.【HIGH QUALITY】﹣Made of Durable DIE-Casting Aluminum Housing and Polycarbonate Lens, Ribbed Design for Efficient Cooling ,Great Strength and Lightweight. Rustproof and Shock-Proof. Sealed Housing, Water-proof IP67.【EASY TO INSTALL】﹣Plug & Play for Headlights ,LED Ballast, LED CANBUS & H4/H13 Adapter Included - Usually in 20 Minutes or Less. NOTE: 2017 - 2018 JKs with OEM LED headlights will require a headlight bracket for installation (Sold separately:B07DPBMNL4)【FITMENT】- 97-06 Jeep Wrangler TJ, 04-06 Jeep Wrangler LJ Unlimited, 07-18 Jeep Wrangler Unlimited JK 2 & 4 Door, 92-01 AM General Hummer, 03-09 Hummer H1 & H2
Halos take a little bit of wiring knowledge, can you/husband splice wires?
For $250 and under you'll be looking at Amazon headlights, they're relatively hit or miss, I have a set and am at 2+ years now of them running fine. Some people have them die sooner.
Xprite I believe is the leader of cheap headlights: Xprite 7" Inch LED Halo Headlights for Jeep Wrangler JK TJ LJ 1997-2018(DOT Approved),CREE LED Chip, 80W 9600 Lumens Hi/Lo Beam with Halo Ring Angel Eyes DRL https://www.amazon.com/dp/B00WL8X3HQ/ref=cm_sw_r_cp_apa_i_CXv3CbP1CH4J8
Basically you'll need some dielectric grease, some scotch locks with dielectric grease already in them, a test light, lots of electrical tape, and zip ties. That and a thin t10 or t15 torx screw driver to aim the headlights afterwards.
The halo wire would get scotch locked to the running light in the fender (test light to determine the positive wire), taped up, and then the headlights themselves are plug and play. Just be sure to use the grease on the connections to prevent corrosion, and then tape it all up to keep water out.
Takes like 1-2 hours.
Also, of you live where it's snows a lot, the LEDS don't get hot enough to melt snow. So while they're 1000% brighter than stock halogen, the LEDS are useless in blizzard driving. I have halogen KC lights when it's heavy snow driving.
Good luck!
Right here
Just a side note, I had to cut into a part when installing. If you have any questions if you do decide to get em, please hit me up.
Aftermarket headlights.
Xprite 7" Inch Round 80W 9600 Lumens Hi/Lo Beam Cree LED Headlights With Halo Ring Angel Eyes DRL For Jeep Wrangler JK TJ LJ 1997 - 2017 (DOT Approved https://www.amazon.com/dp/B00WL8X3HQ/ref=cm_sw_r_cp_apip_PkWcPShaURdlT
They are great! They turn amber for the turn signal.
http://www.amazon.com/Xprite-Round-Lumens-Headlights-Wrangler/dp/B00WL8X3HQ?ie=UTF8&psc=1&redirect=true&ref_=oh_aui_detailpage_o02_s00