Top products from r/VapeXhale

We found 8 product mentions on r/VapeXhale. We ranked the 6 resulting products by number of redditors who mentioned them. Here are the top 20.

Next page

Top comments that mention products on r/VapeXhale:

u/Delbunk · 2 pointsr/VapeXhale

Sure! I use them at work all the time. It's basically a water basin with ultrasonic transducers under it. The ultrasonic waves create cavitation in the part immersed in the basin. This means microscopic bubbles of gas are created on the part where it interfaces with the liquid it is immersed in (in our case IPA) which dislodges contaminants like particles, built up resin, etc.

Now, so that I don't need to fill my ultrasonicator basin with liters of cleaning solution, I fill it with water. I then fill a small beaker with IPA, put my stainless steel VapeXhale baskets in the IPA (after blowing out most of the dry AVB) then place the beaker in the water filled ultrasonicator and turn it on for 5 minutes. Then I take the stainless baskets out, rinse them once in clean IPA, and let them air dry. Cleans them pretty easily and effortlessly. It does a good job with the vapexnails too.

My ultrasonicator can heat the water in the basin, I find if my IPA in the beaker is heated with the water it cleans much much faster. Cover your IPA beaker in foil so it doesn't all evaporate. Here's a link to my exact unit, from Amazon

There are cheaper, smaller units and ones without heaters if cost is a concern. I wanted one that would last, had a heater, and was a bit larger. The plastic basket is good for cleaning glassware without worry of chipping.

u/dontfeedphils · 1 pointr/VapeXhale

I actually got it from Vapexhale, but I think it was a limited run because it's been a while since I've seen it on the website. For an ultrasonic cleaner you can do something like this. I soak the nails and baskets in the ultrasonic cleaner filled with the highest concentration isopropal alcohol I can find. Usually soak them overnight or for a day, but it doesn't have to be that long, and I'll just turn on the ultrasonic cleaner here and there during that time.

​

Then when I'm ready I'll take them out, brush them off good to remove the remaining stains, soak in clean iso for a bit, dry off, and then finally burn them off in the vape with it set to the highest temp (in case it needs to be said, always be careful with iso around heat, otherwise you might lose some hair or go boom).

u/RandomGuyinACorner · 2 pointsr/VapeXhale

They sure do. I had one growing up that was about the size of a quarter when it was open and thinner thank a pen. Had a button at the butt of it that would open and close the claw

edit-Check it

https://www.amazon.com/Flex-Cable-4-Finger-Retriever-Pro-Tools/dp/B006ZEOXJY/ref=sr_1_3?ie=UTF8&qid=1484438083&sr=8-3&keywords=drain+claw

u/MiataEnt · 2 pointsr/VapeXhale

This guy's post is a few posts down. It's tits! I bought the same case and it's wonderful!
https://www.reddit.com/r/VapeXhale/comments/4gb4u2/anyone_built_a_decent_travel_case_using_a_pelican/d2gml8h

Pelican 1450 Case with Foam (Camera, Gun, Equipment, Multi-Purpose) - Orange https://www.amazon.com/dp/B00009XVL7/ref=cm_sw_r_cp_apa_nprFybE9QVA78