Top products from r/cables

We found 11 product mentions on r/cables. We ranked the 9 resulting products by number of redditors who mentioned them. Here are the top 20.

Next page

Top comments that mention products on r/cables:

u/StaleMemeMaker · 1 pointr/cables

Tldr at the end

I can't find any schematics for the cable so I'm not 100% sure it would work, but judging by some size comparisons, I think you could use some jumper cables meant for breadboards. If you could give me the size of the port of an individual pin of the 8 pin connector I can verify.

If the size is 2.54mm then for around $6 you can get: Multicolored Breadboard Dupont Jumper Wires - ALLUS J7011 120Pcs 3in1 Ribbon Cables Kit, Male to Male (M/M), Female to Female (F/F), Male to Female (M/F) for Arduino and Raspberry Pi https://www.amazon.com/dp/B073X7P6N2/ref=cm_sw_r_cp_apa_i_oseBDb0RSX6HQ.

You can get a 10 foot 1/4 TRS for ~$6 on Amazon: Hosa CSS-110 1/4" TRS to 1/4" TRS Balanced Interconnect Cable, 10 Feet https://www.amazon.com/dp/B000068NYH/ref=cm_sw_r_cp_apa_i_7ueBDb0M84YBM.

You're looking at about $7 for the xlr: AmazonBasics XLR Male to Female Microphone Cable - 6 Feet, Black https://www.amazon.com/dp/B01JNLTTKS/ref=cm_sw_r_cp_apa_i_0weBDbQNK67CW

If you have a trs cable, jumper cables, or an xlr cable at your house it will be cheaper. You would also need a soldering iron and some solder ~$10-$15.

It depends on the supplies you need. Assuming you don't have the cables but you have the soldering iron you're looking at about $20. Otherwise it is the same price.

Tldr; it's only $10 cheaper if you don't have a spare xlr, 1/4 TRS, or jumper cables. If you don't have any of the cables as well as the soldering iron, it's the same price.

u/Kadir27 · 1 pointr/cables

Based on the white control box you need a 12V and 6 amp power supply. Something like this https://www.amazon.com/110V-220V-Security-ZUEXT-Converter-Transformer/dp/B07DR83JL5


That one at least seems to have adapters for the two wire interface. Otherwise you will be splicing and soldering cables.

u/WubbGmbaa · 1 pointr/cables

that looks like a c8 connection, but polarized unusually. A C7 power cable should work, but be careful, because C7 is omnidirectional. If the light has no markings for which side is hot and which one's neutral, you're probably fine.
here's a link

u/TheOddPerson · 1 pointr/cables

What you could use are RCA extension cords to get from the speakers to the Y cable.

https://www.amazon.com/C2G-13041-Velocity-Stereo-Extension/dp/B0002J1TUO

u/KeyboardGunner · 1 pointr/cables

That's a micro usb 3.0 cable. One side (not shown in your pic) is the common usb A 3.0 connector and the side you're showing is the usb 3.0 micro B connector. These cables are most frequently used with usb 3.0 external hard drives.

Example cable