Reddit reviews 194 LED Bulbs, Widely Used as Car Truck Interior Dome Map Door Courtesy Marker License Plate Lights, Super Bright 6000K White with High Power Chipsets for T10 168 2825 LED Bulbs Replacement (10 PCS)
We found 3 Reddit comments about 194 LED Bulbs, Widely Used as Car Truck Interior Dome Map Door Courtesy Marker License Plate Lights, Super Bright 6000K White with High Power Chipsets for T10 168 2825 LED Bulbs Replacement (10 PCS). Here are the top ones, ranked by their Reddit score.
200% Brighter: Pack of 10, Voltage: 12V, Power: 2W/PC, 6000K white. These 194 led bulbs are 2 times brighter than halogen and low power consumption for longer life span.Mini Design: Small enough and strong adaptability to fit your car. Easy to install, no drilling, no wiring, no damage, directly replace the original stock bulbs.Fits Sockets: These 194 LED bulbs are compatible with 194, 168, T10, W5W, 2825 sockets. Easy to install, just plug and play. Canbus error free, no error after installation.Wide Application: These 194 bulbs can be used for license plate light, map lights, dome light, parking lights, front/rear side marker lights, trunk cargo room lights, turn signal lights, reading lights, glove box lights, inner tail light etc.Important Note:Please double check your vehicles owner’s manual or the original bulb to confirm the correct light size you need before placing the order.
So it is actually a 3 part ordeal.
The actual fog lights since my car didn't come with them, and the stalk. Then I did some c-shaped drl since I have leds in my high beams and the factory drl doesn't work with leds, but then the c-shaped drl didn't work for a little bit so I bought the drl turn signals, and then the previous c-shaped ones started working again. I will just post all of my mods below:
Fog lamps with brackets : https://www.amazon.com/dp/B01FL8DPWU?ref=ppx_pop_mob_ap_share
Light stalk : https://www.amazon.com/dp/B00AWO7XOK?ref=ppx_pop_mob_ap_share
C-shaped DRL : https://www.amazon.com/dp/B014P7LPEI?ref=ppx_pop_mob_ap_share
Sequential LED Turn signals with DRL : https://s.click.aliexpress.com/e/5veD22k
9005 LED High Beam : https://www.amazon.com/dp/B075J9S4DT?ref=ppx_pop_mob_ap_share
H11 55W HID Low Beam : https://www.amazon.com/dp/B07CMKT2F4?ref=ppx_pop_mob_ap_share
7440 7443 LED Brake/Tail Light : https://www.amazon.com/dp/B07GTKLF32?ref=ppx_pop_mob_ap_share
7440 LED Turn Signal (rear) : https://www.amazon.com/dp/B07Q8RZRZV?ref=ppx_pop_mob_ap_share
194 LED License plate/used as side markers in the front/a couple other places : https://www.amazon.com/dp/B07BT23WVC?ref=ppx_pop_mob_ap_share
194 LED side marker bulbs (not used but the correct ones if you want yellow, I liked the white and it was what I had when the originals burnt out but didn't ever change them from the above link) : https://www.amazon.com/dp/B01KY7GCXW?ref=ppx_pop_mob_ap_share
License plate smoke : https://www.amazon.com/dp/B007LICQ9M?ref=ppx_pop_mob_ap_share
Grille : https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F254096211721
K&N 33-2480 Air Filter : https://www.amazon.com/dp/B00CR9WVPE/ref=cm_sw_r_cp_api_i_VfS6CbNBD59AQ
I had my rims done by a local company, they are the factory 16" painted gloss black. My mazda emblem is actually a long story, but essentially it is just scuffed up with sand paper ready to be painted but I liked the look and stuck it back on the way it is. I have also installed car play, and 3D printed a shift knob. The factory bose system was a little lacking and put a small under seat sub in to help fill the sound, but am still not happy with it, so that's a future project.
Some near future plans for the car include the aero kit, and I'll post the links to those here too:
Front Bumper Lip Air Dam : https://www.amazon.com/dp/B01FTUE8EY/ref=cm_sw_r_cp_api_i_bdS6Cb2X8Y22M
Black Mirror caps : https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F283050942561
Side skirts : https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F391544070112
And the rear diffuser : https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F113007041503
If you're interested you could change out all the interior lighting to LED. The door courtesy lights. The window visor lights. Trunk light. Parking lights. License plate light. Switching to LEDs will modernize the car.
I used these LEDs
Out of the ten, one was flickering on me. But the others have been working properly. Makes my car look really nice.
The only thing I haven't changed out yet is the side mirror lights because I believe they're quite difficult to change.
https://www.amazon.com/dp/B07BT23WVC/ref=cm_sw_r_cp_apip_xvMSPG3oC81n9