Reddit reviews 3 Gallon Aluminum Vacuum Chamber to Degass Urethanes, Silicones and Epoxies
We found 2 Reddit comments about 3 Gallon Aluminum Vacuum Chamber to Degass Urethanes, Silicones and Epoxies. Here are the top ones, ranked by their Reddit score.
3 Gallon BestValueVacs Professional Grade Vacuum Chamber used to degas silicones, epoxies, essential oils and urethanes only to name a few common applicationsOur silicone gasket has a patent pending design that allows it to be used over 10,000 times without deteriorationThe chambers are 100% designed, tested and built in Chicago, IllinoisFor applications using solvents or stabilization resin our GlassVac chamber must be purchased to prevent damage to the lidInternal Dimensions: 9
Interesting idea! I went on a hunt and this is the coolest thing I've found:
It's done with a process called plastination:
> The water and fat are replaced by certain plastics, yielding specimens that can be touched, do not smell or decay, and even retain most properties of the original sample.
They're been doing this since 1970s so I figure there's probably a guide online. Next logical step was a search for "DIY plastination":
I do not have any evidence that the same procedure would work on mushroom flesh, other than the flickr link above.
EDIT:
Per the plastination patent by Gunther von Hagens:
>EXAMPLE 3
>A globular cactus having a diameter of approximately 15 cm was partly hollowed out from its root end by means of a curette, and it was then immersed sequentially for three hours each in 50% aqueous acetone, pure acetone, and dichloromethane. Thereafter it was immersed in a solution of a commercial epoxy resin prepolymer stable at low temperature, but curing at elevated temperature. The vat holding the prepolymer and the immersed cactus was stored in a vacuum at 10° C. for eight hours, whereby all volatile solvent was extracted. When drained of excess prepolymer and held in an oven at 40° C. for six hours, the cactus hardened, but otherwise retained its original appearance and color.
Just curious how much a DIY setup would cost so I made a shopping list:
Here's my setup:
Vacuum Chamber: https://www.amazon.com/gp/product/B00I3Q8D2K
$117
Pump:
https://www.amazon.com/gp/product/B012CFTYX4
$52
That pot will hold a lot of wood, but you also need a couple gallons of Catus Juice to fill it. Grab a cheap toaster oven from Salvation Army to cure.
Listen to /u/Glock19mos. I don't typically dye (I purchase mine dyed) and his pictures speak volumes about his capabilities with the process.