Reddit reviews BTECH QHM22 Platinum Series IP54 Rainproof Shoulder Speaker Mic for BaoFeng, BTECH, Kenwood Radios
We found 8 Reddit comments about BTECH QHM22 Platinum Series IP54 Rainproof Shoulder Speaker Mic for BaoFeng, BTECH, Kenwood Radios. Here are the top ones, ranked by their Reddit score.
High impact casing and High Grade re-enforced cabling, 8 Position Reinforced Spring ClipWaterproof Heavy Duty Remote Hand/Shoulder Mic with Speaker For "Kenwood 2-Pin Accessory" Radios (BaoFeng, AnyTone, and others)Add a 3.5mm listen only earpiece for the ultimate accessory solution in loud environments! Pair with the QHM01 Earpiece.It is built with a impact resistant PVC casing (IP54), for Shock, wind, dust, and splash resistance. It is a High quality microphone with Crystal clear audioCompatible with all BaoFeng, BTECH, some Wouxun, AnyTone, TYT, and Kenwood Radios
This bad boy right here
BTECH QHM22 Platinum Series IP54 Rainproof Shoulder Speaker Mic for BaoFeng, BTECH, Kenwood Radios https://www.amazon.com/dp/B00Z4X3MM6/ref=cm_sw_r_cp_apa_i_zYMXCbV4MABYS
We use the Baofeng BF-F9 V2+ with Nagoya 701c antenna and QHM22 waterproof speaker/mic.
While inexpensive, these are full fledged HAM radio transceivers, not toys. You can't just take them out of the box and turn them on like walkie-talkies you buy at Walmart. They have to be properly programmed to talk to each other on the right frequency, including any tone coded squelch you wish to use.
Not that I'm a HAM radio expert or anything, but you do have to kind of know what you are doing to use these. They are capable of transmitting on frequencies you absolutely should not be using, like police, fire, ems, s&r, government, commercial, etc. It's also worth noting that unless you have an FCC license, you can't actually use these radios legally. However if you are just using them for occasionally dirt bike chit chat, using them responsibly, on the correct frequencies, and not pissing off other users, the chances of being caught are basically zero.
Bottom line is that these cheap Chinese HAM radios work great for dirt biking I have had great success, they have much better range and performance than cheap 'bubble-pack' FRS radios. But they do take a little research and effort to learn how to use them.
For my mic i use this.
https://www.amazon.com/gp/aw/d/B00Z4X3MM6/ref=mp_s_a_1_1?ie=UTF8&qid=1468473927&sr=8-1&pi=AC_SX236_SY340_QL65&keywords=BaoFeng+QHM22+Platinum+Series+IP54+Rainproof+Shoulder+Speaker+Mic
It has a 3.5mm jack for a headphone/earbud. I modified a set of headphones and fit them into the ears of my mask. I run a full paintball mask so a normal all in one headset won't work for me.
My teammates can hear me clearly.
Stay away from throat mics or bone conduction unless you get the real deal. Knockoffs don't cut it and your transmission will either be muted or garbled.
The Motorola RSMs only work with Motorola radios. The btech one can be found here: https://www.amazon.com/BTECH-QHM22-Platinum-Rainproof-Shoulder/dp/B00Z4X3MM6
Is this the one you're talking about?
BTECH QHM22 Platinum Series IP54 Rainproof Shoulder Speaker Mic for BaoFeng, BTECH, Kenwood Radios https://www.amazon.com/dp/B00Z4X3MM6/ref=cm_sw_r_cp_apa_i_wGB8Cb3D40FV0
I've seen them with number buttons, which this one doesn't have. Not a big deal?
As for the antenna, would that be for general use, or with your UV5R? Would an antenna like that be overkill for the 5W the UV5R spits out?
> https://www.amazon.com/BTECH-QHM22-Platinum-Rainproof-Shoulder/dp/B00Z4X3MM6/
I'm pretty sure this is the one I have. Maybe my Mazda3 is noisy, but I can't hear anything on the road. It works great on my desk.
I have used this hand mic mobile and it got PLENTY loud enough for me. If you need a 3.5mm jack, it also has that built in and I guess you could route the cable down but I don't think you'd need to.
https://www.amazon.com/BTECH-QHM22-Platinum-Rainproof-Shoulder/dp/B00Z4X3MM6/
It also sounds very clean on DMR, tested on my GD-77 and MD-380.
Dear Pi-people,
I want to make wall mounted phones and hang them throughout the city. You can leave voicemails or talk 1-0-1 if someone is on the other line. It will be a closed network of about 10 units.
Your advice on mic/telephone: i think the shoulder mics are really cool for this project. But i have no clue how to connect it to the pi. Will an usb soundcard be ok? I don’t know if these 2 pin connectors on the shoulder mics fit the standard usb cards.
Furthermore I don’t know if the PTT (push to talk) will still function or how to make that interact with the pi; recognising when mic is on or off (maybe sound levels?).
Second option would be to attach a “retro” phone. Anyone have any experience/ suggestions? Regarding software as well (Is Asterisk a solution or Mumble + voicerecord for voicemail?)
https://www.amazon.com/BTECH-QHM22-Platinum-Rainproof-Shoulder/dp/B00Z4X3MM6/ref=sr_1_3?s=electronics&ie=UTF8&qid=1518681063&sr=1-3&keywords=shoulder+mic
https://www.amazon.com/Sabrent-External-Adapter-Windows-AU-MMSA/dp/B00IRVQ0F8/ref=zg_bs_3015427011_1?_encoding=UTF8&psc=1&refRID=TEF3DD19MRMX3V5B2PSN
Thanks in advance!