Reddit reviews Honeywell International VR8200A2132 Valve
We found 2 Reddit comments about Honeywell International VR8200A2132 Valve. Here are the top ones, ranked by their Reddit score.
Includes: One 1/2" x 3/8" straight busing, one 3/4" straighr flange, one hex wrench, one pilot compressing fitting for 1/4" O.D. tubing, 393691 Natural to LP gas conversion kitGas valves include manual valve, two automatic operators, servo pressure regulator and pilot adjustmentSolenoid-operated first automatic valve opens on thermostat call for heat; closes when call for heat endsDiaphragm-operated second automatic valve opens under control of regulator; closes if gas or power supply is interruptedManufacturer Model # VR8200A2132Genuine Replacement PartHoneywell item1/2" NPT inlet x 1/2" NPT outlet
Hey there, figured I'd give an update.
Replaced both our super old mercury thermostat and the thermocouple. Verified couple is giving ~22mv to the gas valve, which should be enough right?
I might be able to squeeze out a little more voltage by adjusting how much the end is in the pilot light.
I can hold down the red ignition button for 5sec, release and furnace kicks over and heats house to desired temp from thermostat. But once at temperature, it's not turning on by itself again (regularly at least).
So I think that's some progress from original post least. Kinda thinking the only thing left to replace is the actual gas valve right? Was looking at this Honeywell international valve.
So we know it's not a 24volt issue right? What's the stat?
I would use something like this http://www.amazon.com/Honeywell-VR8200A2132-International-Valve/dp/B00ECV2W90.