Reddit reviews KINGPRINT KFB2.0 Controller Board for Reprap Mendel Prusa I3 Kossel 3D Printer
We found 2 Reddit comments about KINGPRINT KFB2.0 Controller Board for Reprap Mendel Prusa I3 Kossel 3D Printer. Here are the top ones, ranked by their Reddit score.
I successfully got Klipper up and running on my CR10 using this ramps 1.4 board and some cheap A4988s.
https://amzn.com/gp/product/B072KRFDHK/
the CR10 end-stops can just sorta plug into the board, and most everything wires right up. Just had to swap my hot-end fan and parts cooler fan, and flip the connector for the hot-end fan (polarity is flipped for some reason). I also had to invert Y-axis and Z-axis in the config.
No test prints yet just did a motor and heater/thermistor test.
So far this thing is awesome! Easy to flash. Easy to setup. headless printer. :D
Dang, I'm a little out of the loop... Would you have any suggestions? I did find this one, (cheap, but that's the name of the game right now).