Reddit reviews MasterStat Thermostat for Evaporative Coolers
We found 2 Reddit comments about MasterStat Thermostat for Evaporative Coolers. Here are the top ones, ranked by their Reddit score.
Designed to control any ducted evaporative cooler with a 2-speed motor up to 1 HP at 120-Volt or 2 HP at 240-VoltOnboard sensor has a control range of 50 to 90 Degrees F; Outputs provided are auto/manual, pump, fan and timer modesIf power is interrupted while unit is operating, the unit will resume in the mode active during power loss; Rain proof control box includedKit includes wall control thermostat, 2-speed control, wire nut for common earth connection; spare 3.15-Amp fuse for control, jumper wire for link to N-link; Easy to install in an existing outlet box - minimal wiring requiredCompatible with MasterCool ADA51/71, ADA5112/7112, ASA51/71, ASA5112/7112, AUA51/71, AUA5112/7112, all AD1C-contractors series, all AS1C-contractors series, all AU1C-contractors series, all AD2C-contractors series, AS2C-contractors series, AU2C-contractors series; Compatible with UltraCool ADA50/70, ADA50-12/70-12, ASA50/70, ASA50-12/ASA70-12, AUA50/70, AUA50-12/70-12 ada, ADA51/71-series, ADA5
You are correct. I was thinking of a swamp cooler thermostat, that is line voltage:
https://www.amazon.com/Champion-MasterStat-Thermostat-Evaporative-Coolers/dp/B00CORM70S
You set it and forget it. It switches between speed, and controls the water as needed.
Thank you so much! I am about to embark on this project. If I already have a "MasterStat" thermostat installed and hooked up to my evaporative cooler, will I need the White Rodgers relay to hook up to an ecobee 3?
If so, where did you mount the rodgers box?