Reddit reviews Micro Swiss MK10 Plated Wear Resistant Nozzle for PTFE Lined Hotend M7 Threads 1.75 mm, 0.4mm (Flash Forge/Dremel/Wanhao), Bright Nickel
We found 4 Reddit comments about Micro Swiss MK10 Plated Wear Resistant Nozzle for PTFE Lined Hotend M7 Threads 1.75 mm, 0.4mm (Flash Forge/Dremel/Wanhao), Bright Nickel. Here are the top ones, ranked by their Reddit score.
USA made Micro-Swiss Plated Brass Wear Resistant Nozzles extend nozzle life dramatically when using abrasive materials.Fit a large variety of machines, check listing name carefully to make sure it fits your printer, or get in touch with us if you are unsure.Ultra-hard coating creates a low friction nozzle that outlasts uncoated brass. Brass base material retains thermal conductivity for unchanged thermal performance.
Welcome! Happy to help.
As a note, I found a better rated plated nozzle on Amazon here. It can be used without upgrading to the full metal hotend (even though it is also by MicroSwiss) if that is what you are looking for.
Just for comparison, this is my Benchy.
Dremel 3D20 with a Micro-Swiss HW-NOZ-MK10-04 recently installed.
PLA layer height .2mm, 20% fill, build speed 40mm/s, temp 220C. Sliced in Cura 3.1.0.
Wished I had printed it a little faster to get closer to your speed, but maybe this help to reinforce slower speed may help.
I just ordered this one for mine. https://www.amazon.com/gp/product/B01BDL4NKM/ref=ox_sc_act_title_1?smid=ATVPDKIKX0DER&psc=1
This is my favorite nozzle for Wanhao -
https://www.amazon.com/Micro-Swiss-HW-NOZ-MK10-04-Plated-Resistant-Nozzles/dp/B01BDL4NKM/ref=pd_bxgy_328_2?_encoding=UTF8&psc=1&refRID=DDCZV1Y9Q7PXDZKTPBR9
I tried the All metal hotend, and couldn’t get it to work. For some reason the cold end wasn’t cold enough and clogging was continuous. I went back to the teflon tube and this nozzle and it’s been spectacular. Simple, and it just works.