Reddit reviews Pruveeo Hard Wire Kit for Dash Cam, Mini USB Port, 12V to 5V, DC 12V - 30V Car Charger Cable Kit

I just hard wired my dash cam over the weekend. Surprisingly easy to do. You need an interior panel remover tool and pliers or fuse removal tool to remove a fuse, but that's pretty much it. I ran mine through the headliner(just stuffed it in neatly), down the passenger A pillar and through to the fuse box. Connected the ground to the ground bolt near/under the running plate. Took me and my friend an hour because I was so scared of breaking something removing the interior pannels. You absolutely need the panel tool imo. Dashcam turns on and off with the car 👌

edit: the wires I used. It's a direct replacement for any 15A fuse (no add-a-circuit needed), I used the fuse for the fog lights and just threw that 15A fuse in my tool box in case it's needed in the future. I had quite a bit of slack left over so I just zip-tied it into a neat wad and kept it above the fuse box. I also used some foam to stuff into the panel right below the A-pillar, I'm not sure what that part is called, but there's a lot of room in there and I didn't want any rattle noise coming from a free floating wire in there.

I bought a Nexar Dash Cam and this wiring kit. Install took about 15-20 minutes by myself with very simple tools. Very happy with it so far.

Honestly, I think you could save some $$$ go with a Rexing V1. I've mine for almost two years and it's been perfect. Great daytime quality and fair night time quality. Some of the videos online are deceiving because people didn't set it to 720p or 1080p. It allows your to set your recording times from 1 minute, 3 minutes, or 5 minutes.

I have it hardwired into my Acura with this kit using an add a fuse.