Reddit reviews ReliaBot Hot Bed Power Expansion Board Heating Controller MOSFET High Current Load Module 25A 12V or 24V for 3D Printer
We found 2 Reddit comments about ReliaBot Hot Bed Power Expansion Board Heating Controller MOSFET High Current Load Module 25A 12V or 24V for 3D Printer. Here are the top ones, ranked by their Reddit score.
Voltage: 12V to 24V; Max Current: 25ACan work stably when the current is not more than 25AMaximum power of the heated bed: Over 300W (12V) or 600W (24V)Make sure that the cables that connect to the controller board and hotbed can withstand high currentWe recommend using a 24V power supply when using a heat bed with high power
Good to know about the nozzle. I'll probably be grabbing the ones I linked. Or some with at least a couple 4 star reviews if I can find them.
I've heard that you can be fine going with mirror but I'm hoping to print more with more expensive/complicated filaments (PETG) so I want to be safe with higher temps.
Let me tell you, I love me some clones. But I haven't had any trouble with my hotend yet. I always get consistent temps withing +-.3C
I just feel like I can get more for my money by upgrading the bed you know?
The only change I've made to the printer is the vent for the fan, and the addition of this MOSFET for the bed. Never even thought about swapping out the control board. What kind of benefits can that bring?
https://www.amazon.com/ReliaBot-Expansion-Heating-Controller-Current/dp/B078S6221G/
Would you recommend this? And then it is a simple swap out with the mechanical relay, nothing else is needed?