Reddit reviews DERNORD 120V 2000W Immersion Water Heater Submersible Heating Element Heater Element with 1 Inch NPT Fitting
We found 2 Reddit comments about DERNORD 120V 2000W Immersion Water Heater Submersible Heating Element Heater Element with 1 Inch NPT Fitting. Here are the top ones, ranked by their Reddit score.
High Watt Density Stainless Steel Immersion Water Heater ElementProvides 2000w 120v of powerStainless steel surface has electropolishUL and cUL listed to the safety standardsSupplied with silicon sealing washer which is flexible and waterproof
If you buy a high enough wattage heat stick or element, you should be able to boil. It'll come down to time. It looks like 2000w will get 6 gallons from 72 to 212 in about 65 minutes and 10 gallons in 105 minutes. It's not as simple as linear, but you could heat to strike in ~40 and to boil in ~40 assuming the 6gal. That's not too bad.
I use 2x 6500w elements with the ripple back version of this element
You'll need to do some wiring with a bare cord. You can find a guide that should help here
If your garage has enough amps to run a 240v, or you already have one, you can get a 6500w element for ~27amps (6500/240) which can be supplied off 8guage wire and a 30amp plug. If you drive an electric car, or your family does, you can convince them to install a level 2 charger :P
edit: if you go this route, you should also get a GFCI plug or breaker since you're dealing with water and electricity.
DERNORD 120V 2000W Immersion Water Heater Submersible Heating Element Heater Element with 1 Inch NPT Fitting https://www.amazon.com/dp/B01M34BZBO/ref=cm_sw_r_cp_apa_i_GsDADbH3B8BKX