Reddit reviews Draft Warehouse Faucet And Hex Nut Wrench with Vinyl Coating - Heavy Duty
We found 2 Reddit comments about Draft Warehouse Faucet And Hex Nut Wrench with Vinyl Coating - Heavy Duty. Here are the top ones, ranked by their Reddit score.
Soft vinyl gripHeavy duty constructionOne side is a spanner wrench for hex nuts, other side is to tighten faucets to shanks or towers.Fits any standard shank coupling nuts and beer hex nut.A very handy tool to have
Draft Warehouse Faucet and Hex Nut Wrench with Vinyl Coating, Heavy Duty https://www.amazon.com/dp/B00829HKEK/ref=cm_sw_r_other_apa_XOavybTT6PTZP
Here you go. Works great!
Sounds like you're done with the conversion itself, but this is what I used: http://www.homebrewtalk.com/showthread.php?t=453105
Maybe you have the same fridge even! The only thing that doesn't say to get is the right tool to fasten the faucets on the inside of the tower. It's a bitch without the proper tool. It's just so tight in the 2 faucet towers. Here is the one I got: http://www.amazon.com/dp/B00829HKEK/ref=pd_lpo_sbs_dp_ss_3?pf_rd_p=1944687702&pf_rd_s=lpo-top-stripe-1&pf_rd_t=201&pf_rd_i=B00J97GJHI&pf_rd_m=ATVPDKIKX0DER&pf_rd_r=1NH6YW8176WY4Y44J4VD
If you're doing a 1 faucet tower I wouldn't worry about it though. Also, I use a bungee cord to secure the CO2 to the small shelf.
I just copy and pasted the equipment descriptions into google for things I didn't have. As for the copper pipes, that's what I did too. I got some wall brackets for the pipes and screwed them into the wall inside and ran them up the tower using some elbow connectors. I got the pipes and brackets at Home Depot, along with the copper pipe cutter tool. I did that instead of a fan.