Reddit reviews HOODDEAL 50 PCS Solder Seal Wire Waterproof Connectors Heat Shrink Low Temperature Melt Soldering Electrical Wiring Terminals Industrial Grade Insulated Connectors Kit for Marine and Automotive
We found 3 Reddit comments about HOODDEAL 50 PCS Solder Seal Wire Waterproof Connectors Heat Shrink Low Temperature Melt Soldering Electrical Wiring Terminals Industrial Grade Insulated Connectors Kit for Marine and Automotive. Here are the top ones, ranked by their Reddit score.
☞ INCLUDE: Red-20pcs+Blue-15pcs+White-10pcs+Yellow-5pcs heat shrink solder seal butt terminals meet your all needs. Strip Wires, Insert into terminal, and then Heat. Quick and Easy - Save time and improve efficiency.☞ ADHESIVE TUBING: 2:1 heat shrink ratio; Dual-walled design - Outside Polyolefin tubing provides insulation and improves pullout strength; Hot melt adhesive inside ensures wires tightly connected and improve waterproof performance of solder connectors.☞ EXCELLENT ALLOY JOINTS : Each electrical solder seal connectors features low temperature melt alloy placed inside of polyolefin tube to hold joints strong. Ensure less voltage drop, prevent wiring failures and reduce equipment downtime. Safe for Automotive and Marine applications.☞ Versatile Kit - Wide variety of sizes sorted in clear case - not only easy to carry but also store them to be safe from dust, dirt and water so as to be used well in the future; Good products, life no worries!✉ 100% Money-back Guarantee：Please don't hesitate to contact us if you meet any problems before ordering or after receiving our products. Refund / Replacement is allowed for any reasonable reasons.
https://www.amazon.com/HOODDEAL-Waterproof-Solder-Connectors-Soldering/dp/B00ESXX74G
i love these connectors with solder built into them. stick your two wires in and use a heat gun and you're done.
https://www.amazon.com/HOODDEAL-Waterproof-Solder-Connectors-Soldering/dp/B00ESXX74G
Ah, so the issue is that you only have one battery on the board at one time, and the charging port is on the board. So you can't charge one while you're riding?
The best solution (in my opinion) is to get a new enclosure that can hold both batteries, and then wire them up in parallel with an xt60 y-connector and the jst y-connector linked above. Swapping batteries on the meepo involves too many screws and too much fuss to sound super practical for me. Apparently this enclosure can hold two (or even three) of those batteries comfortably- https://psychotiller.com/product/the-durban
With that said, soldering those parts above would definitely work. I'd use solder seals personally, they're the easiest way to permanently bond (and insulate) wires together
https://www.amazon.com/HOODDEAL-Waterproof-Solder-Connectors-Soldering/dp/B00ESXX74G
It's a low-temp solder+ thick shrinkwrap + adhesive all in one. Good stuff for pretty much any electronics use (if you didn't know of them already).
Putting both batteries on one charger would definitely increase the charging time. Course, you'll also need to charge it less, because bigger batteries. So, there's that.
Check out this thread for more info- https://www.reddit.com/r/ElectricSkateboarding/comments/75zkqv/meepo_battery_upgrade/
u/Jreamer said he used the connector I linked above, seems to have no issues with it (that I've heard of).