Reddit reviews KINGPRINT 3D Printer MKS Gen V1.4 Controller Board Mega 2560 R3 Motherboard RepRap Ramps1.4 Compatible with USB
We found 4 Reddit comments about KINGPRINT 3D Printer MKS Gen V1.4 Controller Board Mega 2560 R3 Motherboard RepRap Ramps1.4 Compatible with USB. Here are the top ones, ranked by their Reddit score.
Mega 2560 and ramps1.4 set on a board, to solve complicated Ramps1.4 combination of interfaces, the problem of failure prone.
Replace the motor drive, drive and support A4988 DRV8825 TMC2208 TMC2130 drive.
The circuit board with high-quality 4-layer, heat and made a special optimization; ramps are 2 shelves.
Using high-quality MOSFET, and better heat dissipation.
Using a dedicated power chip, support 12V-24V power input, the voltage converter chip to solve the heat problem Ramps.
Replace the motor drive, drive and support A4988 DRV8825 TMC2208 TMC2130 drive.
The circuit board with high-quality 4-layer, heat and made a special optimization; ramps are 2 shelves.
Using high-quality MOSFET, and better heat dissipation.
Using a dedicated power chip, support 12V-24V power input, the voltage converter chip to solve the heat problem Ramps.
I have the MKS gen 1.4 that came with my FT5 R2 and I love it, super easy to work on as everything is clearly labelled, does it's job nicely. They're pretty cheap on Amazon, $35 any day of the week.
I don't have much experience with other board styles, but the Ramps was $8ish on Amazon. I don't know if you need additional hardware going that route, but the MKS will function on it's own.
Mks 1.4: https://www.amazon.com/dp/B072ZZ3YQW/ref=cm_sw_r_cp_awdb_t1_SivJBbHRKHRHQ
On a tight budget....Suggesting a $170 board.....
A MKS Gen would be a good choice if all your stepper drivers still work.
https://www.amazon.com/KINGPRINT-Controller-Motherboard-Ramps1-4-Compatible/dp/B072ZZ3YQW/ref=sr_1_3?ie=UTF8&qid=1510702491&sr=8-3&keywords=mks+gen&dpID=51YMIpuw%252BhL&preST=_SX342_QL70_&dpSrc=srch
I am also using a V6 hotend. Probably wont have to change your PID values.
I went with:
MKS Gen 1.4 - https://www.amazon.com/gp/product/B072ZZ3YQW
Stepper Motor Driver x 5 - https://www.amazon.com/gp/product/B01FFFYVV8
there are boards like these (not a specific choose, just the first i've found) which seems to be just an mega ans a ramps board on a single board. What are the advantages disadvantages of those over a ramps and arduino?