Reddit reviews Monoprice 102801 24k Gold Plated Speaker Banana Plugs, Closed Screw Type (1 Pair)

We found 2 Reddit comments about Monoprice 102801 24k Gold Plated Speaker Banana Plugs, Closed Screw Type (1 Pair). Here are the top ones, ranked by their Reddit score.

Can accept bare wire or spades / Can accept 12 to 18 AWG speaker wiresColor coded black/red rings for maintaining proper polaritySecure, positive contact with binding postsCorrosion resistant, 24K gold plated brass plugEach order includes ONE pair (2 plugs total)

Check price on Amazon

2 Reddit comments about Monoprice 102801 24k Gold Plated Speaker Banana Plugs, Closed Screw Type (1 Pair):

u/nocko · 1 pointr/tDCS

Your best bet would be to buy cut the electrode end of the fixed cable off. Then you can strip the ends and use a screw or solder banana connectors attached to end to interface with the Amerex sponge electrodes.

u/JbstormburstADV · 1 pointr/audiophile

Agree with this setup so much. Only thing I did was downgrade to the Dayton SUB-1000 and switched out the SMSL A2 for a Topping TP-22 and a Schiit Modi 2. I wanted the modularity of having separate components, plus the electrical isolation was a big help.

If you do decided to go this route, you'll need to do four runs of speaker cable (one from each speaker to the sub, and one for each channel on the sub to the amp) and buy an RCA to RCA cable. The Modi 2 will come with a USB that'll connect to a computer and Win7+ will install drivers automatically. I would also recommend getting these. A good set of banana plugs will save you a lot of frustration if you need speaker wire going to terminals that can accept these. It's too bad, though, that only the amp I use feature the right connector.