Reddit reviews Neoprene Sheet, 50A Durometer, Smooth Finish, No Backing, Black, 0.032" Thickness, 36" Width, 60" Length
We found 2 Reddit comments about Neoprene Sheet, 50A Durometer, Smooth Finish, No Backing, Black, 0.032" Thickness, 36" Width, 60" Length. Here are the top ones, ranked by their Reddit score.
Oil Resistant and Abrasion ResistantImpact and Weather ResistantFlame Resistant
Go to Home Depot [or any home improvement store] and look for high quality 3/4" plywood. I normally go for the 2' x 2' pieces, and they're about $15 to $20. I don't care, as this is good stuff, and usually void free. You can have them rip it down to your desired size, but I do that myself.
Round the corners off [I have this metal flange that's the perfect diameter... maybe 2"]. DON'T round the edges, but sand it a lot [at least up to 220 grit]. Seal it with a good quality poly [I use Helmsman spar urethane, as it's really resistant].
Them, get some rubber [this stuff might be a bit too thin], some spray adhesive, and glue that stuff down. The more glue, the merrier, but make sure it goes on smooth. Trim the excess. Wait a few hours [preferably overnight], apply pallet tape and mount it.
Good as a real pallet. It might cost a bit to make, but it's still like 25% of an aluminum one.
Would this work well?
https://www.amazon.com/Neoprene-Durometer-Smooth-Backing-Thickness/dp/B00KL8JVGU