Reddit reviews Oneway Multi Gauge
We found 2 Reddit comments about Oneway Multi Gauge. Here are the top ones, ranked by their Reddit score.
Solid 1 1/4 " thick cast ironMachined 90 degrees on three sidesIncludes dial indicator
Your out feed table is just out a bit. With sharp blades I run my set my table(outfeed) between .001-.002 lower than top dead center of my blades. I get dead flat joints in 12foot long boards. I use one of these to get me there, I highly recommend any body with a planer or jointer to invest in one. http://www.amazon.com/Oneway-2289-Multi-Gauge/dp/B0002SA98I
Craftsman Table Saw Model # $150
Shop Fox model #G8826 fence system $275
Freud P410 Premier Fusion 10-Inch 40 Tooth Hi-ATB General Purpose Saw Blade $80
Wilton 15” drill press $100
Parks 12” planer $600 This requires a little road trip
Atlas 6” jointer $150 Model #
Delta 10” bandsaw, Powerkraft radial arm saw and Rockwell contractor table saw $200
I would resell one of the tablesaws Just pick the nicest one and sell the other.
Oneway Multi Gauge $97 This is for setting the jointer perfectly and the dial indicator can be removed to make planer setting jig as described by Bob Vaughan (see youtube) or fine woodworking 107.
Angle block set for machine setup $30
Bessey Bar Clamps $14x3 plus maybe $10x3 for bars Say $75 total
Stanley sweetheart chisel set of 4 $80
This leaves $243 left for misc things like drill bits, planer/jointer knives or sharpening F style clamps a cordless drill, random orbit sander, sand paper ect.