Reddit reviews ZITRADES Ethernet Shield W5100 Development boardor for Arduino UNO Mega 2560 1280 328 UNR by ZITRADES
We found 5 Reddit comments about ZITRADES Ethernet Shield W5100 Development boardor for Arduino UNO Mega 2560 1280 328 UNR by ZITRADES. Here are the top ones, ranked by their Reddit score.
1. Based on the W5100Based on the Wiznet W5100 allows an Arduino board to connect to the internet.2. Has a standard RJ-45 connection, with an integrated line transformer and Power over Ethernet enabled.3. Can use to store files for serving over the network.4. Compatible with the for Arduino Duemilanove (168 or 328), Uno as well as Mega (1280/2560).5. Can be accessed using the Mini SD TF library.
BTW the extra driver is used for the second extruder, both Z motors are driven in parallel from a single driver (half the current to both motors). Of course you could also use a single-stepper Z axis, which I recommend.
You will likely not be able to control the extra fans (hotend and electronics box) with the Printrboard, but they could be wired always on. On a stock VORON with RAMPS the hotend fan only runs when the hotend is >50C and the electronics box fan runs only when the printer is being used.
I guess it could work but with a cheapo RAMPS + Arduino kit for $40, it might be worth just skipping the Printrboard.
3D Printer Controller Kit for Arduino... https://www.amazon.com/dp/B019TNELNU?ref=yo_pop_ma_swf
This display, which has the SD card slot, came with the RAMPS kit I bought. This one - https://www.amazon.com/gp/product/B019TNELNU/ref=oh_aui_detailpage_o08_s00?ie=UTF8&psc=1
It's a ramps board, here's the exact board (including stepper drivers):
https://www.amazon.com/gp/product/B019TNELNU/ref=oh_aui_search_detailpage?ie=UTF8&psc=1
> stepper drivers, microstepping, steps per mm.
I don't have the setup for steps/mm but what would that have to do with thermal runaway?
> Have you tried swapping hotends/ changing to single?
it's happening on both hotends, so swapping hotends won't make a difference.
> What message you see on screen when it happens
The message on the screen is what's in the title,t hat there was a thermal runaway.
> does the printer restart itself?
The firmware isn't programmed to restart itself after a thermal runaway. You need to hard reboot it.
> Does it happen always at the same time/when?
Not that I have noticed.
> Edit: Do you print from SD card or through the cable?
Cable via octoprint.
You can get Ramps boards for like 15 bucks on Amazon. Go big and just use this https://www.amazon.com/Printer-Controller-Kit-Arduino-Upgraded/dp/B019TNELNU/