Best grill igniters according to redditors
We found 6 Reddit comments discussing the best grill igniters. We ranked the 3 resulting products by number of redditors who mentioned them. Here are the top 20.
We found 6 Reddit comments discussing the best grill igniters. We ranked the 3 resulting products by number of redditors who mentioned them. Here are the top 20.
This could definitely trip a breaker or cause a bad fire.
If I was in this situation, I'd use a piezoelectric starter from a BBQ or something. Or ya know, just the spark from the lighter.
They're like $10.
You can upgrade the ash pan to the enclosed one, just buy the part and snap it on the legs. Weber 65143 Ash Catcher Assy for 2015 22.5" One Touch Grills https://www.amazon.com/dp/B00MMIKZWQ/ref=cm_sw_r_cp_api_UqUKBbJWBD193
They do not sell the carts, you’ll need a side table or you can build a cart if you’re inclined. That’s what I did, didn’t want to buy a brand new grill just for that.
You can also upgrade with a slow n sear, the Weber gourmet grate and accessories.
[Ignitor ](http://www.Surefire.com/ Piezo Igniter / Grill igniter w/ 30,000 16v Piezo Ignition Sparks w/Special Introductory Price https://www.amazon.com/dp/B019JEI7AW/ref=cm_sw_r_cp_apa_9qB6ybJ8V7GTZ) from Amazon.
Degrease and wire brush the box then paint with high temp grill paint. Don't worry about the burner being rusted as long as you are still getting an even flame.
If there is any sign of dry rot on the gas line, replace it. Better to be safe than dead.
Run the racks through the dishwasher then hit them with some steel wool. Rub them with some peanut oil until they get good and greasy from some pork.
I don't see a water pan or chip tray, so you'll want to check out the manufacturer website for a replacement.scratch that, they're in there on second look.I added the enclosed ash catcher to my Weber Kettle a couple years ago. My kettle was about ten years old, but was new enough that the upgraded catcher popped right in. I seem remember having to remove the clean-out handle to get the enclosed catcher installed, but I could be wrong. If your clean-out fins are rusty or worn out, you might want to replace those at the same time.
Here's the ash catcher unit I ordered: https://www.amazon.com/gp/product/B00MMIKZWQ
https://www.amazon.com/gp/aw/d/B00MMIKZWQ/ref=mp_s_a_1_1?ie=UTF8&qid=1526183349&sr=8-1&pi=AC_SX236_SY340_QL65&keywords=weber+ash+catcher+22.5
The igniter button doesn't have to be on the torch. It could be in a box on the floor with the wire running up to the torch. Generic pushbutton igniter kit from Amazon