Reddit reviews 60-Degree V-Groove Bit, 1/4-Inch Shank, 1/2-Inch Diameter, Carbide-Tipped
We found 2 Reddit comments about 60-Degree V-Groove Bit, 1/4-Inch Shank, 1/2-Inch Diameter, Carbide-Tipped. Here are the top ones, ranked by their Reddit score.
7/16-Inch Cutting Length, 60 degree Cutting Angle, 2-17/64-Inch Overall LengthMake delicate grooves and incisions with laser precisionRaise bit and produce fine point incision or work the whole diameter to render highlighted lettersNon-Stick Orange Shield Coating, Anti-Kickback Design, Equipped with Bearing2 SinterHip Hi-Density Industrial Chrome Carbide cutting edges for long-lasting performance
I make signs (including nameplates), and stuff for a small etsy shop I have on the side. I've found that typically, harder woods machine better. I make nameplates for people out of Walnut or Maple usually. Also, I find that using a 60 degree bit for smaller lettering looks really nice.
The nameplates I make are 9in x 3in, and 3/8in thick. I also make a stand for them out of a contrasting wood (if I use maple for the nameplate, I make the stand out of walnut). The stand allows me to set the nameplate at an angle if it will be displayed on a desk.
Here's the bit I use: Amazon Link
Let me know if you have any questions!
Try this link
CMT 858.001.11 60 degree Laser Point Bit, 1/4-Inch Shank, 1/2-Inch Diameter, Carbide-Tipped by CMT http://www.amazon.com/dp/B000P4NSYG/ref=cm_sw_r_udp_awd_0Emktb12XDFND