Reddit reviews BIQU MKS-BASE V1.5 Plate Controller Board for 3D Printer Ramps 1.4
We found 7 Reddit comments about BIQU MKS-BASE V1.5 Plate Controller Board for 3D Printer Ramps 1.4. Here are the top ones, ranked by their Reddit score.
Arduino MEGA compatible Atmega2560 and FT232 processors are compatible with all RAMPS class firmware.4 layers PCB, optimize heat dissipation.Easy DISPLAY + SD-CARD connector, RepRap Discount SmartController compatible pin header on board.Up to 5 motor driver with A4982.Recoverable fuse for short-circuit protection.
I would recommend the below laser, it works as described. Having a separate control module seems to be something of a personal preference based on the project, I mounted it on the X-Axis carriage above the laser.
2.5W Laser Module
I'm very happy with the below MKS-Base V1.6 (?!?) controller board. Apart from having to replace all of the Solidoodle connectors with JST-XH connectors it has been very easy to work with. There are a bunch of comments about various polarities being reversed, but I haven't seen it yet. I have not hooked up the LCD yet, which is one of the wiring concerns mentioned in the Amazon reviews.
MKS Base v1.6 Controller Board
This crimper is the bomb! I debated this unit (~$17) vs the PA-09 (~$40), and am extremely happy with my choice. The lack of reviews on this one made me a bit skittish, but I have another IWISS crimper that works well and I went with the brand recognition (and it's cheaper.)
IWISS Crimper Tool
Yes But only 1 motor Turns if I swap the pins on the control board then then that one moves and not the other.
Yes.
Control Board
https://www.amazon.com/gp/product/B01FVTQQ2K/ref=oh_aui_detailpage_o03_s00?ie=UTF8&psc=1 that is the one I ordered.
I would get the mks base 1.5 then: https://www.amazon.com/BIQU-MKS-BASE-Plate-Controller-Printer/dp/B01FVTQQ2K/ its an all in one board with built in steppers. Would allow you to install the latest marlin firmware and doesnt require external mosfets like the stock melzi board does.
I would use the original board for a quick replacement, but a great upgrade would be this mks board, it supports additional fans, 12 or 24 volts, dual extrusion, and is only marginally more expensive.
It should be a plug and play replacement for the anet board.
I'd recommend flashing marlin on it as well for either the anet or mks board.
Edit, The only downside is that is doesn't include an sd card slot. Usually the screen that ships with the mks board has the sd card slot. Personally, i either print wirelessly with Octoprint or just plug my laptop in for the print.
You might consider the one I bought (less expensive) : BIQU MKS-BASE V1.5 Plate Controller Board for 3D Printer Ramps 1.4
It runs the exact same Arduino code that a RAMPS board does, you just don't have all of the extra pieces :)
https://www.amazon.com/BIQU-MKS-BASE-Plate-Controller-Printer/dp/B01FVTQQ2K/ref=pd_day0_328_1?_encoding=UTF8&pd_rd_i=B01FVTQQ2K&pd_rd_r=TKYWTCW8F7J7M5YEDH11&pd_rd_w=ggiKg&pd_rd_wg=ok4cB&psc=1&refRID=TKYWTCW8F7J7M5YEDH11