Reddit reviews Dremel EZ476 1 1/2-Inch EZ Lock Rotary Tool Cut-Off Wheels For Plastic - 5 pack
We found 3 Reddit comments about Dremel EZ476 1 1/2-Inch EZ Lock Rotary Tool Cut-Off Wheels For Plastic - 5 pack. Here are the top ones, ranked by their Reddit score.
The first cut-off wheel designed specifically for cutting plasticCut-off wheels last 2 times longer than current fiberglass- reinforced cut-off wheelsCompatible with all Dremel rotary toolsCut-off wheels labeled for easy identificationFirst patented system of it’s kind
I used a dremel, and to every one saying OH IT'LL MELT IT...Nah, it actually worked faster, better, and easier than a hacksaw. Dremel makes a "plastic" cutting blade that works wonders. If you just try to cut straight through, then yes, it will heat it up too fast. What I did was cut a section, pull away for 2-3 seconds, turn the tube a little and cut another section. 3-4 cuts and boom it's off. Takes less than 30 seconds. You will have to use a chamfer tool like this: https://www.amazon.com/XSPC-PETG-Acrylic-Tubing-Chamfer/dp/B016B29RK4 but again, that only takes another 20 seconds. Then using some 400 grit sandpaper to finish it off.
I used a dremel 3000 series, set it to power 8, and used this cutting wheel : https://www.amazon.com/Dremel-EZ476-2-Inch-Cut-Off-Plastic/dp/B000FBLRW4
A dremel. I heated up an X-acto knife on my stove and cut them out, but I don't recommend it as it can be dangerous.
I wouldn't have said anything if I hadn't cut plastic with a dremel before.
Here you go cheif. Let me know how it works.
The instructions also say to "Go slower."