Reddit reviews Finish Line Fiber Grip Carbon Fiber Bicycle Assembly Gel, 1.75-Ounce Tube
We found 7 Reddit comments about Finish Line Fiber Grip Carbon Fiber Bicycle Assembly Gel, 1.75-Ounce Tube. Here are the top ones, ranked by their Reddit score.
Fiber Grip(TM): Carbon Fiber Assembly Gel is specially designed to reduce slippage between clamped carbon fiber surfaces. Fiber Grip eliminates the need to over tighten clamps to achieve secure connections.Apply Fiber Grip in a thin film to clamping areas of stems, handlebars, seat posts, and seat tubes to eliminate the need for over tightening, which can cause internal fractures and fatigue of carbon fiber parts.Tested and approved by leading carbon fiber component manufacturers. Clear, Non-staining Non-Toxic
You'll need more torque than necessary to prevent slipping. Use a carbon paste instead.
Also you can get a "fibre grip" paste to help stop carbon parts slipping. I use it for my lockon grips on my carbon bars.
I transitioned into working on my bikes almost entirely by myself (Wheel building/suspension service/bearings excluded) and this is the exact path I went down as well. Here is everything I bought from Amazon:
The same $50 tool kit
Torque wrench
Cable/housing/wire cutter
Chain/quick link pliers
Wet/Dry Chain lubes
Park Tool grease
Degreaser
Blue Loctite
Carbon grip paste
And some additional small things like cables, cable end caps, ferrules, zip ties, etc. A set of needle nose pliers can be handy to help push/pull stubborn cables/housings as well.
Also, to make working on the bike 10x easier, I recommend getting a stand. I use this one because I am space constrained and it folds up nice and small, but there are probably better ones out there.
It seems like a lot of $$ to lay out at first, but it pays for itself pretty quickly compared to taking the bike to a shop every time you need to do something to it. Basically everything you need to do can be found on YouTube as well.
Sorry to hear about you getting hurt.
I'm not familiar with the assembly paste Shimano ships with their carbon fiber parts, but here's what I use: Finish Line Fiber Grip
With barely any torque it locks my bars in place better than full torque spec did without it, and it gets a lot better with additional torque. I also carry this tiny torque wrench on longer rides so I have no excuse for my bars coming loose.
THIS! Don't overtighten it. Get some of this gel/paste stuff before you crack your seatpost (like I did). https://smile.amazon.com/Finish-Line-Bicycle-Assembly-1-75-Ounce/dp/B0012RIEM6/
All of that will likely make it more slippery. Just use friction paste!
https://www.amazon.com/Finish-Line-Bicycle-Assembly-1-75-Ounce/dp/B0012RIEM6/ref=sr_1_1?ie=UTF8&qid=1502601421&sr=8-1&keywords=finish+line+fiber+grip
I use this on all compression joint faces: seat tube, saddle rails, stem/steerer/bars, and not just on carbon.
Have you thought about Carbon Assembly Paste? it's pretty much grease with a fine grit that aids in creating more friction/grip when you clamp things.
http://www.amazon.com/Finish-Line-Bicycle-Assembly-1-75-Ounce/dp/B0012RIEM6