Reddit reviews InstallGear 0/2/4 Gauge AWG in-Line ANL Fuse Holder with 150 Amp Fuse

An overengineered car stereo fuse holder like this one

https://www.amazon.com/InstallGear-Gauge-Line-Fuse-Holder/dp/B01CT4ZJHS

Thanks man after following ur advice, I found that the trailing edge did not give any voltage feedback but the side closest to the battery did give feedback. Running a continuity test I further found out the fuse failed. Whats interesting is that the fuse looks intact from just looking at it. The fuse is a AGU 80 amp 5AG80A
Saying that I have found two problems with my installation that were the likely causes of my issues. 1)I had left the rubber inside the terminal of one end on the fuse holder. There is now a black singe mark inside the terminal. 2) The fuse is a AGU 80 amp fuse, after doing some research I have found that the recommended fuse for 4 gauge wire is 125 Amps. I have went out and bought a new inline fuse holder with a ANL 150 amp fuse.

Thanks for the advice.

I was thinking of making my old holder with wood as the plastic ones seem to melt for some people. I've never had that happen. I was looking at install gear ones already. Would it be better to get one that needs terminal ring or just the screw in type? This is the one I was considering https://www.amazon.com/InstallGear-Gauge-Line-Fuse-Holder/dp/B01CT4ZJHS/ref=mp_s_a_1_4?ie=UTF8&qid=1549041992&sr=8-4&pi=AC_SX236_SY340_FMwebp_QL65&keywords=anl+fuse+holder

Ok so ill be ordering this one.

Could water have potentially gotten to the fuse and cause it to blow? I saw slightly exposed wire where the fuse connects to the wire via allen key that is now covered with electrical tape.