Reddit reviews IRWIN Hanson 12002 T-Handle Tap Wrenches, 1/4" - 1/2"
We found 4 Reddit comments about IRWIN Hanson 12002 T-Handle Tap Wrenches, 1/4" - 1/2". Here are the top ones, ranked by their Reddit score.
Made of shock-resistant and heat treated S2 steel for maximum strength and hardnessIdeal for maintenance and repair workManufactured in ChinaFor taps 1/4 to 1/2"Sliding handle with spring tension TapMay be extended full length in either direction for more leverageHas positive grip knurled knot
Why would you buy a new die? There is a kit for removing stuck dies.
https://www.amazon.com/gp/product/B004Y6ZJQ6/ref=oh_aui_search_detailpage?ie=UTF8&psc=1
You will need a tap wrench.. https://www.amazon.com/gp/product/B00004YOB1/ref=oh_aui_search_detailpage?ie=UTF8&psc=1
There are plenty of videos of how to use this stuff to remove a case.. Dies are fine, no need to replace.
Manual t-handle? You could leave it somewhat loose and slip it over the top.
Hanson 12002 T-Handle Tap Wrenches https://www.amazon.com/dp/B00004YOB1/ref=cm_sw_r_cp_api_FPqDzbS5H4CYM
it's definitely a simple build. the tapping part is maybe the simplest part, heh. it's intimidating (at least it was for me the first time) since it's out of our normal realm, but tbh metal is a lot like really hard, dense wood. you can drill it, cut it, sand it, etc. you just need the right tools. For this purpose, I used a drill/tap set like this one and a tap wrench like this (though that tap wrench kinda sucks). use a little tap fluid and go slow. back it out every couple turns or any time you feel significant resistance, wipe the tap quickly on a cloth or something, then thread it right back in and keep going. it's so much easier than it seems :)
I used these two when I installed a FDV 510 for a DNA build.
http://www.amazon.com/gp/product/B0002JT0XW/ref=oh_aui_detailpage_o05_s00?ie=UTF8&psc=1
http://www.amazon.com/gp/product/B00004YOB1/ref=oh_aui_detailpage_o06_s00?ie=UTF8&psc=1