Reddit reviews SMAKN 5V Lithium Battery Charging TP4056 Board 5 Volt Mini USB 1A Charger Module DIY
We found 3 Reddit comments about SMAKN 5V Lithium Battery Charging TP4056 Board 5 Volt Mini USB 1A Charger Module DIY. Here are the top ones, ranked by their Reddit score.
Input voltage: 4.5V-5.5VFull charge voltage: 4.2VLEDs: red - charging | green - chargedInput interface: mini USB and Solder platesWork temperature: -10ºC to 85ºC
Ok, so I do have 1 question: The game boy only turns on when the usb is plugged in. Does everything look right? The only thing I can think of is I might have bad dsi batteries.
Photo
edit: ok I think I may have been sent the wrong board. I ordered this, but the one I got has a micro b port
You will need a charger that supports LiPo batteries. Here's the cheapest solution.
I don't buy much from amazon now, they are a little over priced in many cases... But here are amazon links to things I've used in the past that all get the job done well.
1/4 x 1/8 magnets for the cover http://www.amazon.com/dp/B008PGMG58/ref=cm_sw_r_udp_awd_recftb0T3KWCC
1/8 x 1/32 magnets I put in the box http://www.amazon.com/dp/104800001X/ref=cm_sw_r_udp_awd_6ncftb060AZJS
A cheap 1amp mini USB charger, most micro USB chargers are only 500ma http://www.amazon.com/dp/B00HJNX0DU/ref=cm_sw_r_udp_awd_kncftb1XHMGQ2
Volt display http://www.amazon.com/dp/B00D76EJAG/ref=cm_sw_r_udp_awd_Uicftb0VSS4AW
You can wire up those in your mod, but the charger can only charge a single cell or parallel cells, not if they are in series... But since you are going unregulated, then if you did do 2 batteries then you would wire them in parallel anyways.
Good luck and have fun! Building is great!