Reddit reviews Tool Gift For Men Right Angle Drill & Screwdriver Attachment Gift Tool Kit Tight Fit Hex Bit 90 Degree Angle Adapter Power Drill Accessory Driver Extension 00110
We found 2 Reddit comments about Tool Gift For Men Right Angle Drill & Screwdriver Attachment Gift Tool Kit Tight Fit Hex Bit 90 Degree Angle Adapter Power Drill Accessory Driver Extension 00110. Here are the top ones, ranked by their Reddit score.
Drill holes and drive or remove screws in near impossible places; Save time, money and frustrationWorks with manual or power hex screwdrivers and all power drills; Accepts standard 1/4 inch hex bitsIncludes 6 aircraft quality drill bits & 4 industrial quality screwdriver bits; A tool gift ideaLong insulated grip allows deep reach into tight spots; Locking pop-in/out chuck holds bits securelyA gift idea for birthday, Christmas, Father's Day tools; PROULDLY AMERICAN MADE
Not gonna lie, that's an extreme angle, but if it works for you, go for it.
Moving the strap button is relatively easy.
The primary problem is that for the screw angle to be correct, the neck will interfere with the drill.
Easiest solution is to get a drill that has a right angle built into it or a right angle attachment(these can be a bit tricky to use, so get assistance).
First tape off around the area you are drilling. I like to drape a towel to protect the finish, as well.
Take the screw out of your current strap button and get a dill bit anywhere from 1/2 to 3/4 of the diameter of that screw. Just don't use a bit that's roughly the same or larger.
Put some tape on the drill bit that's about 3/4 the length of the button strap screw to mark how deep you need to drill.
Using the screw, make a little indentation in the finish so the drill bit won't wander around as you start drilling.
Go slowly.
Once you've gotten to the correct depth, you're golden.
If you have a bar of soap in the house, just run the screw across it a couple of times to pick up some of the wax(or you can use a candle).
This will make it easier to screw in.
Because of the neck you will probably need a right angle screw driver, although a shorter scerwdriver might work too.
I would do this by hand and not use a power tool just to be on the safe side.
Attach the button to the screw and screw that puppy in.
Profit!
:)
Good luck!
Maybe not this exact model, but a 90 degree screwdriver allows you to adjust mixture screws on the bottom of carbs without removing the whole assembly or trying to get just a flathead tip in there and dropping it repeatedly.
http://www.amazon.com/gp/aw/d/B0039Q1FH4?pc_redir=1412262569&robot_redir=1#