Reddit Reddit reviews Frost King R738H Self-Stick Foam Rubber Foal Weatherseal, 3/8" W, 7/16" T, 10 ft L, Black

We found 2 Reddit comments about Frost King R738H Self-Stick Foam Rubber Foal Weatherseal, 3/8" W, 7/16" T, 10 ft L, Black. Here are the top ones, ranked by their Reddit score.

Tools & Home Improvement
HVAC
Weatherproofing Products
Weather Stripping
Building Supplies
Frost King R738H Self-Stick Foam Rubber Foal Weatherseal, 3/8
Item Weight: 0.2 lbCountry of Origin: ChinaColor: BlackBrand name: ThermwellItem Width: 0.39 InchesIncluded Components: GlueMasking-TapeIncluded Components: Glue , Masking-Tape
Check price on Amazon

2 Reddit comments about Frost King R738H Self-Stick Foam Rubber Foal Weatherseal, 3/8" W, 7/16" T, 10 ft L, Black:

u/IchigoKyger · 48 pointsr/SwitchHaxing

I would only suggest doing this mod if you are extremely comfortable with a soldering iron. I'm not responsible if you mess up your Joy-Con. With that being said below are the things I used to make this possible:

Parts

  1. Take apart your Joy-Con.
  2. Run two wires from the Pin 10 pad and the ground as shown in this picture: https://i.imgur.com/mpbtqVQ.jpg Leave some extra wire so you can cut to size later. Soldering to the ground plain can be a pain I brought my Iron up to 750 F, used a bigger tip and had to hold it there for awhile before it would become molten.
  3. Re-assemble your Joy-Con up to putting the back on it.
  4. Take the 6mm x 6mm x 6mm Tactile push button and cut off the leads on one side and bend the other leads flat.
  5. Cut two small pieces of weather seal and place them on top of each other and hot-glue the button to the top of it.
  6. Place your weather seal and button down to the left side below the battery so it doen't interfere with the rail.
  7. Cut your wires to size and solder each wire to their own lead on the button.
  8. Place your back cover on to the Joy-Con to see where the button is and make a mark in the center of the button.
  9. Remove the back cover and slowly drill a hole stepping up bit sizes until the button fits in.
  10. Re-assemble and enjoy!

    More pictures

u/IOnlyLurk · 1 pointr/headphones

>With respect to the headband mod, keep in mind that mutilating the headband kills resale value. Some folks have made custom universal headbands or transplanted the K701 headbands (which are expensive!). Wrapping Beyerdynamic replacement headband around the Q701 headband works, but you will have to cut the stock headband to size to allow the Beyer clips to fasten.

You can just get some adhesive foam and put it between the bumps.