Reddit reviews ImpressArt 1" Nylon Hammer

I much prefer coin rings with the writing on the outside and inside, like this.

I tried to make one for my girlfriend's birthday this year, but it was fairly difficult.

I used a punch and die set to punch out the center of the coin, and then put the coin on a ring mandrel and then hammered it down the taper slowly with a nylon faced hammer.

The biggest problem is that my girlfriends ring finger is quite small and I couldn't get the ring any smaller than size 8. I may have to pick up another mandrel with a really narrow top so that I can punch out a smaller hole from the coin to begin with.


I'm sure with enough practice I'll get it looking great, and this method is much quicker than the spoon method (I tried that one first).

Not knockin OPs ring though.. it looks great so far. I know how long it takes to get to that point!