Reddit reviews Lucas Oil 10005 Red 'N' Tacky Grease - 14 Oz.

I was motivated by the recent thread with the X rated pics of the frame, so this weekend I spent quite a lot of time inspecting the bike everywhere with a flashlight for rust (owned less than 1 year). As someone who leaves a puddle on the floor after a workout, it only made sense that had to leave impact on steel. While Peloton suggests you to wipe down the bike after a ride, the places where most people would clean, such as the large smooth surface areas, may keep the bike looking good but are actually not problem areas. The problem is everywhere you miss--seat bolt and the threads on the frame, connectors, the gap to the shaft on the left pedal, the bolt and opening where the cover on the right meets the frame, underside of frame where the welds are, outer pedal threads, metal screws, etc. For the seat handle, not only were the threads in bad shape, but also I could see rust on the front and back of the handle where it meets the bolt. Basically, the more I looked for rust, the more I found. Left untreated for a few years, I think it would have evolved into bigger problems down the road.

I used Ospho on many of the painted parts and the bolts and let it sit for a day. Getting to some parts required something like a toothpick or a dental tool with the paper towel scrap to scrub. Ospho (HD equivalent here) makes rust inert and preps it for painting, then used a touch up brush and applied some black rustoleum paint to the painted areas. Then I used white lithium grease(spray) to protect all the moving parts and bolts, and even into the seat handle. To protect the underbelly of the frame where the welds are, I'm tempted to apply some stickier grease like Red and Tacky to completely seal those areas from sweat and air after now that the paint has dried, because it is not an area that can be easily and properly cleaned every time. Going forward I'll be looking it over much more frequently.

I'm in the same boat - mine arrives today from CMP - so I've been doing the same as you.

I got this book from Amazon, and it's proven to be a good resource for me while I've been waiting for my rifle.

One thing you'll need for sure is grease to lubricate all the rotating parts. After doing a bit of research, I arrived at this grease off Amazon.

You'll of course need ammo and enbloc clips. CMP is also the best/cheapest source of both of those, so add that to your order for the bayonet.

Finally this website is another good resource.

Enjoy your rifle!!